Question about 1996 Jeep Grand Cherokee

1 Answer

2003 Jeep Grand Cherokee electrical issue

This is a 2003 Jeep Grand Cherokee. Replaced widow regulator and 2 months later all these things quit working. Windows, AC, Interior lights won't automatically work, temp readout, and if you lock or unlock with remote, the lights will not flash.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Sounds like a stray wire, check for frayed wires touching the chassis or take the reg back out and see if the problems rectify

Posted on Feb 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Our 2007 Jeep Grand Cherokee randomly won't start.


change the wires that go to the starter i had the same problem fixed now with no problems

Jun 20, 2012 | 2005 Jeep Grand Cherokee

1 Answer

Constantly replacing fan relay on my 2003 Jeep Cherokee


You should try getting the factory part because this is a common issue amongst jeep grand Cherokee's. it could also be the location because it is behind the bumper underneath the head light and that is an unusual spot for it to be placed.

Apr 08, 2010 | 2003 Jeep Grand Cherokee

1 Answer

Electric rear window falls down


poss your window track is broken or off track take the door panel off to see the track to see if its still going up or down or poss bad widow regulator

Apr 04, 2010 | 2004 Jeep Grand Cherokee

1 Answer

1999 Jeep Grand Cherokee Laredo. The front left


Try the hazard switch.Do all the blinkers work?This may be a loose connection to the lamp.The window and lock system are on seperate circuits so very unlikely they are related.There is a seperate relay for the blinker and hazards,so a single blinker not working is either bulb or wiring.Widows are operated by motor so check the fuse, wires and and actuating switch. (Door trims off).Also check its not just jammed.Locks,check fuses,switch wires for damage or looseness and the actuator is working.Check the actu. rods are not loose are bent.(need the door trims off for this).Quite a few different things but hope this helps

Sep 11, 2009 | 1999 Jeep Cherokee

2 Answers

Failed window regulators on 2006 Jeep Liberty


This is for an 2002 KJ Liberty, but can help you to identify your problem 08n-Electrical-Systems-Power-Systems (Page 21: Power Windows)

Also in the Section about Body Jeep-KJ-2002-Liberty-Service-Manual-PDF-Secc-23-Body (Page 121 Front Door.

This is for an 2003 KJ Liberty: Jeep-KJ-2003-Liberty-Service-Manual (Page 529, Power Windows).

I hope help you with this. Good luck.







Sep 11, 2009 | 2006 Jeep Liberty

1 Answer

2003 Jeep Grand Cherokee overland climate control problem. 3 months ago replaced regulator, I noticed the plug end on the wire harness was a little melted on the face from over heating. Bought a new...


If the connector was partially burned when you did the work, it will not make good contact. The additional resistance there will cause heating of the wires. Remove each connector from the plug and clean them up. You may need to close them a bit to restore a tight connection. You can usually slide a thin strip of metal behind the connector from the front to bend down the tab that holds it into the plug. If the plug is too melted to use, you can plug each wire into the component without the plug...just wrap each with tape to prevent unwanted contact. Make a diagram of those wires so you know where each goes and keep it for future reference.

Jul 10, 2009 | 2000 Jeep Grand Cherokee

2 Answers

2003 Jeep Grand Cherokee Runs Rough


It sounds like a few different things or a combination of more than one.

  1. The EGR valve
  2. The catalytic converter
  3. The mass airflow sensor

May 09, 2009 | 1998 Jeep Cherokee

1 Answer

Electric Window cable connections


unfortunatly there is no diagram or actual repair for a window regulator. the only fix is to replace the regualtor assembly. ive replaced hundreds of them at the jeep/chrysler/dodge dealer i work at

Jan 05, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1996 Jeep Grand Cherokee Logo

491 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...