Question about 2000 Dodge Intrepid

1 Answer

Anti theft alarm intrepid 2000

Have a short how do you turn it off

Posted by on

  • yadayada
    yadayada May 11, 2010

    If it is factory u can't turn it off.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

Unhook the positive battery cable and leave it off for about 15 minutes then try putting it back on it should disable ir reset it

Posted on Feb 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 explorer alarm disables. Motor dies


Anti-theft system can keep vehicle from starting , Alarm is for vehicle content theft , open door without key alarm sounds (horns) ! PATS - passive anti theft system PATS enables and disables the engine from starting ,it will not cause the engine to die ! You have some other kind of problem ! If the vehicle engine doesn't turn over an red light on top of dash flashes fast ,then you have anti-theft system problem !
PATS differs from the perimeter anti-theft system in that PATS enables and disables the engine from starting. If equipped, the perimeter anti-theft system protects the perimeter of the vehicle (doors, hood and trunk) and sounds an alarm.

Aug 17, 2016 | Cars & Trucks

1 Answer

My 2000 ford taurus won't start I turn the key it turns on but won't turn over. My theft light keeps flashing could that be the reason it won't start?


it can be the issue... some car alarms would cut of gas to prevent theft..... now you are victim of car alarm..... usually car owner have more problems with anti theft systems, than thiefs.....
if you have some remote controlled alarm, try to turn on and off alarm and try again....
if that won't help, usually there is somechanical switch to turn off that alarm, it's usually hidden somewhere and you need key for it...

Feb 23, 2016 | Ford Cars & Trucks

1 Answer

After battery change, the alarm won't stop


Your alarm should turn off with remote. If won't my wild guess is that somehow your alarm got short-circuited.
Does your car start with alarm on but anti-theft turned off? If does, disconnect horns and take your car to alarm installer to get it checked.

Oct 06, 2015 | Cars & Trucks

2 Answers

Isuzu rodeo 2000, LS, anti-theft alarm needs to be reset


This has to do with the Auto's Computer system and should ONLY be done by a Factory Rep who knows what he/she are doing. not a home mechanic chore!!

Jul 16, 2010 | 2000 Isuzu Rodeo

2 Answers

How to reset factory anti theft system dodge intrepid


how to reset the anti theft system for my 2006 dodge ram 1500

Oct 19, 2009 | Cars & Trucks

1 Answer

Anti theft alarm goes off when no one is around mostly at night or early morning sometimes when driving door locks keep locking and unlocking and interior lights go on


You have a short in your Electrical system where the alarm connects to your power assist system or a short in your alarm. Pull the fuse for the alarm and if the problem stops it is the alarm if it continues you will need to trace the connections and make sure they are secure and protected by taping them up.

Aug 27, 2009 | 2000 Dodge Neon

1 Answer

Alarm goes off when I open the door wheather locked or unlocked


On internet there is a manule, disarm the Anti-Theft system. Check door and trunk switches re-engage system.

Jul 29, 2009 | 2002 Dodge Intrepid

1 Answer

Replaced the alternator, now anti theft won't disable


The ignition lock anti-theft switch (19A438) detects if the ignition key cylinder is broken or "slam pulled" during a theft. The ignition lock anti-theft switch is always monitored by the remote anti-theft personality (RAP) module. This allows the alarm system to be triggered in the case that the ignition lock anti-theft switch detects tampering of the ignition key cylinder (even in the event that the alarm is not active at the time).
Refer to the Section 501-14B for more details on the keyless entry remote transmitter (15K601).
The door open warning lamp switch (14018) communicates to the RAP module through the generic electronic module (GEM). This input to the RAP will cause the anti-theft alarm to be sounded if the anti-theft alarm was armed.
The door disarm switches are assembled into both LH and RH lock sets. The door disarm switch must be triggered before the mechanical lock unlocks. This is to prevent the anti-theft alarm from activating when it should have been disarmed.
The RAP module controls the anti-theft system and is the brains of the keyless entry system. The RAP module communicates with the GEM to request that the interior lights be turned ON/OFF with use of the keyless entry remote transmitter, and the GEM communicates to the RAP to inform when the door is opened. Refer to Section 418-00 for inter-module communication.
The RAP module has three wire connectors attached to it:
  • The antenna for the keyless entry remote transmitter.
  • 26 circuit connector (C256).
  • 22 circuit connector (C257).
In addition to the perimeter alarm that uses the door open warning lamp switch, the RAP module also uses the ignition lock anti-theft switch and the autolock/relock feature to prevent theft of the vehicle. For a full description of the autolock/relock system, refer to Section 501-14B .
The THEFT LED is found on the instrument panel between the tachometer scale and the needle pivot point. The LED is illuminated during prearming and flashes when armed or triggered.
Prearming and Arming the System
The system can be armed if:
  • The ignition is OFF.
  • The PANIC alarm is OFF.
  • All doors are closed.
There are two ways to prearm the system:
  • Press the LOCK button on the transmitter.
  • Open a door, press the power door lock button and close the door.
After 30 seconds the system will be armed and the theft indicator in the cluster will flash every two seconds.
Disarming an Untriggered System
An armed system will be disarmed with one of these valid actions:
  1. Pressing the UNLOCK button on the transmitter.
  1. Placing a key in the door and turning to UNLOCK.
  1. Turning the key to RUN or ACC.
The anti-theft alarm can be triggered by the following conditions:
  • The ignition cylinder is damaged with or without the RAP being armed.
  • A door is opened without disarming the armed RAP module.
The remote transmitter can activate a panic alarm which is similar to an anti-theft alarm, but does not deactivate the starter or cause the theft indicator to flash.
Disarming a Triggered System
If the system has been triggered, (the horn honks, the lights flash, and an external starter interrupt relay is engaged), the system can be disarmed by:
  1. Pressing the UNLOCK or PANIC button on the transmitter.
  1. Putting a key in the door and unlocking the door.
  1. Turning the ignition to RUN/ACC (Turning the key to RUN/ACC will not disarm an alarm that has been triggered by the ignition lock anti-theft switch.).

Apr 10, 2009 | 1997 Ford F150 Regular Cab

Not finding what you are looking for?
2000 Dodge Intrepid Logo

Related Topics:

211 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...