Question about 1995 Jeep Grand Cherokee

1 Answer

95 jeep grandcherokee laredo bothback windows won't go up or down

But the front two work correctly.
I tried new switch for the back and still does not work.
Went to the junk yard and got a switch assembly for the drivers
side and still the back windows won't work.

Posted by on

  • Anonymous Feb 26, 2009

    where is the "A" pillar
    I pulled back the drivers door and all wires look good
    Thanks for trying to help and if you got another tip I will
    try it.

  • ccn7 May 11, 2010

    Does it have a child safety switch on main controls?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

Look at the harness between the drivers door and the "A" pillar. Peel back the boot and check the wires in there to see if they are broken.

Posted on Feb 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok my 2001 Grand Cherokee Laredo wont stay in park


Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!

Oct 22, 2015 | Cars & Trucks

1 Answer

No pressure or fluid to rear brakes 99 jeep grand cherokee laredo


check the abs control unit. there is 2 lines that from the master cylinder that feed it,and there is 4 lines that come off it. 2 of the lines go to the front brakes and the other 2 go to the back brakes

Feb 01, 2013 | Cars & Trucks

1 Answer

Whrinng noise in the back of my jeep grandcherokee laredo 1996


CHECK YOUR AXLE. MAKE SURE THE FLUID LEVEL IS GOOD

Feb 15, 2010 | 1996 Jeep Grand Cherokee

1 Answer

1999 Jeep Grand Cherokee Laredo. The front left


Try the hazard switch.Do all the blinkers work?This may be a loose connection to the lamp.The window and lock system are on seperate circuits so very unlikely they are related.There is a seperate relay for the blinker and hazards,so a single blinker not working is either bulb or wiring.Widows are operated by motor so check the fuse, wires and and actuating switch. (Door trims off).Also check its not just jammed.Locks,check fuses,switch wires for damage or looseness and the actuator is working.Check the actu. rods are not loose are bent.(need the door trims off for this).Quite a few different things but hope this helps

Sep 11, 2009 | 1999 Jeep Cherokee

2 Answers

My 1999 jeep grandcherokee power windows are not


REMOVE MASTER SWITCH UNPLUG IT 12V TEST LIGHT YOU SHOULD HAVE TWO HOT WIRES . IF THERES POWER THE PROBLEM IS IN THE WIRING HARNESS FROM THE DOOR TO THE THE VEHICLE. THE WIRES TEND TO BREAK AT THIS POINT. YOU DID CHECK FUSES AND WINDOW RELAY

Jul 08, 2009 | 1999 Jeep Grand Cherokee

4 Answers

Power windows won t work


There are broken wires in the wiring harness between the frame and your driver's side door. These wires control all the windows and door locks in a 95 Jeep. Same thing happened to me. You will have to cut the rubber boot to get it off and check which wires are broken and repair them.

May 30, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Drivers Door Window/Locks aren't working


driver side lock and window switch... if its all one unit... i had a 95 cherokee laredo that did that... changed the switch and it fixed my problem...

Mar 15, 2009 | 2003 Jeep Grand Cherokee

2 Answers

1994 jeep grand cherokee power window problem


most of the time it is wires in the drivers door that break in the loom

Feb 20, 2009 | 1994 Jeep Cherokee

3 Answers

1995 jeep grand cherokee laredo 4x4 all power windows not working


had same problem with 94. in the door jam there is a rubber boot that holds all the wires for your power windows and locks and stuff. remove the boot and check each of the wires in that harness to make sure they are not broke. that's what was wrong with mine on both doors. the wires break with repeated door openings.

Jan 27, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...