Question about 1993 Nissan Altima

1 Answer

No spark from dist power in none out new dist

No spark out dist power in none out

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

Check the rotor, and the coil inside the distributor. Check the distributor cap for any cracks and the rotor. Be sure that the wires , spark plugs are good. And that the distributor is marked when you remove it to make sure the timing is right. there have been cases where the shaft that goes into the oil pump fro the distributor has not engaged into the pump.

Posted on Feb 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have power to my coil but none coming out on my 84 351 Windsor brand new distributor coil is good module came on new distributor I need help ?


Since the coil is getting power you need to get a spark tester or pull a cord of one spark plug and lay it on the engine and have some crank the engine. You should see and hear a spark. If not check fuses and check the ignition module - that is the device that tells the the coil to send a spark. You could also remove the wire from the coil to the dist cap and look for a spark.

Jan 04, 2016 | Cars & Trucks

1 Answer

NO POWER TO THE DISTRIBUTOR ON 87 CADI DEVILLE THERE IS POWER TO CAP


I owned a similar 1986 caddy

12 Volts on pink wire to dist with key on

The top of the cap is the HEI Ignition Coil

Inside dist is the pickup coil (no crank sensor)
& ignition module with the 3 or 4 wires

Maybe the module failed- if you have no spark
at plug wires

Mar 14, 2013 | 1987 Cadillac DeVille

1 Answer

Power to new dist no spark


You need to run a fault code test on the electronic engine control ystem, to do that go here.

Oct 10, 2012 | Cars & Trucks

1 Answer

Crv shut down oil cap lefted off and oil all over engine and truck shutn down checked and found oil fill the spark channel and boots so replace the gasket and plugs and cleaned off the wires and now have...


have you put a new set of plug wires on it. use a spark plug tester, and put it between plug wire and dist, cap. if it is sparking you will see it. if yes and not to plugs put on new plug wires. good-day ! if above checks out. remove dist, cap and see if shaft of dist, is turning. some of the hondas have a plastic type drive gear on bottom of dist, shaft. that goes bad.

Sep 21, 2011 | 2000 Honda CR-V

1 Answer

Wiring an hei distributor


You shouldn't need a spark box because thee coil is located in the dist. cap. You need to run a 12v switched power source to the side of the dist. cap that is marked dist. if it isn't maked it is the term. that is on the front right of the conector pad. the one on the left is for hooking up a tach.

Oct 04, 2009 | 1986 Chevrolet C1500

1 Answer

There is no power going to the dist cap. I put a new coil in but this did not fix it. The spark plugs will not fire. Everything works but the plugs will not fire. The engine just turns. Ichecked the wires...


U have a power wire that has been breached ur gonna have to check continuity to ur power wire at the coil and dist hook one lead to the fuse that supplies power and other lead to to same circuit under hood at coil repeat step with all wires on coil and dist just to be sure.

Apr 03, 2009 | 1992 Plymouth Voyager

1 Answer

No spark


you need a good meter. test your coil, make sure your geting power in and out of your coil. make sure you got a good contact on dist. make sure you got good ground. if none of this helps try getting a new master controller chip. it is usualy located inside or right around the distrub. make sure its grounded properly . also check make sure no contacts are touching on controller hope it helps

Feb 08, 2009 | 1992 Mitsubishi Eclipse

Not finding what you are looking for?
1993 Nissan Altima Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...