Question about 1988 Chevrolet C2500

1 Answer

88 chevy blower motor

How do you take out and replace a blower motor? i got all the screws out and it just dont seem to come out easy. the dash is in the way.. any other ways?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 1,000 Answers

Here is the process, however I have had to "deform" or bend the inner wheel house liner before. But to remove it you will need to:

  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.

  • Good luck, let me know. I just changed one on my 83 C10.
    Regards,

    Posted on Feb 13, 2009

    Add Your Answer

    Uploading: 0%

    my-video-file.mp4

    Complete. Click "Add" to insert your video. Add

    ×

    Loading...
    Loading...

    Related Questions:

    2 Answers

    1996 Dodge Ram Fan motor not blowing at all


    need to try and check power going to blower. Sounds like bad blower

    Feb 22, 2013 | Dodge Ram 2500 Cars & Trucks

    1 Answer

    How to replace 1998 chevy s10 blower motor resistor


    its under the rt side of dash mounted to the heater box held in place by 2 5.5mm screws easy job

    Jan 06, 2013 | 1998 Chevrolet S-10 Pickup

    1 Answer

    How do you access the blower motor on a 1996 Dodge Dakota. It seems that you have to remove the glove box, which doesn't seem easy. Any ideas?


    You should have an access right under and behind your glove box. If you get down and look under your dash just behind the glove box there should be a round plastic cover protruding from under the dash. If you remove the screws and take that off your blower will be right there. Should be pretty easy. I say should because I have experience with a same year durango but not a dakota. Figure their probably about the same. I hope it turns out that easy for you. Good luck.

    Mar 14, 2011 | Dodge Dakota Cars & Trucks

    1 Answer

    The heating switch( fan) works only on #4 position , how can I fix it ?


    replace blower motor resistor located next to blower motor under passenger side of dash.has one connector and two phillips screws securing it.easy to do and part is fairly inexpensive.if replacement part fails i would recommend replacing blower motor also asit is probably drawing too much current and overheating resistor assembly.

    Feb 20, 2011 | 2001 Nissan Sentra

    2 Answers

    I'm trying to find the location of the blower motor for my 93 buick roadmaster with a 5.7 liter motor


    the blower motor is located on the pass side under the dash. calls for .7 hour to replace it relatively easy to replace. just unplug it and undue the little screws that hold it in transfer the fan part if it doesnt come with the motor and replace. hope this helps

    Jan 25, 2011 | Buick Roadmaster Cars & Trucks

    1 Answer

    Hi, i need to remove and replace the blower motor for the a.c./ heater, and dont know where it is located. can you please help?


    Blower Motor Removal & Installation To Remove:
    1. Remove the insulator from under the right side of the dash.
    2. Disconnect the electrical connector from the blower motor.
    3. Remove the blower motor retaining screws.
    4. Remove the blower motor.
    To Install:
    1. Install the blower motor.
    2. Install the blower motor mounting screws.
    3. Connect the electrical connector to the blower motor.
    4. Install the under dash insulator.
    prev.gif next.gif

    Dec 10, 2010 | 1999 Pontiac Grand Prix

    2 Answers

    Heater blower motor only one speed


    It could be the blower resistor, located usually right beside the blower, easy to replace 2 or 3 screws and 1 or 2 plugs and your done.

    Jun 16, 2010 | 2004 Chevrolet TrailBlazer

    1 Answer

    Blower motor still runs when engine is off


    replace the blower motor resistor, this is your problem, this part is not expensive. heres a picture of it and its held in by 2 screws easy to change, hope this helps you.the resistor is located inside on pass/side under the dash near blower motor,ce87732.jpg

    Feb 06, 2010 | 1994 Buick Regal Gran Sport

    1 Answer

    HOW DO I REPLACE HEATER BLOWER IN 1997 JIMMY WITH A/C??


    you are talkin about the blower motorrihgt. f so its easy has pie. look under the pass side dash there should be the motor there is like four or five screw that need to be removed then disconnect the wires going to the motor and wammo its out. dont bream the hamster cage thought because to new motor wont have one. you will have to pry that one of the shaft.no biggie, hey good luck .

    Jan 08, 2010 | 1997 GMC Jimmy

    1 Answer

    Heater blower motor gone in car


    The blower motor is under the dash on the passenger side, and fairly easy to replace as blower motors go, are u sure the problem is not the blower motor speed control resistor? it is very seldom the blower motor goes out, the resistor is right next to the blower held into the air duct with 2 screws.

    Jan 13, 2009 | 1995 Ford Escort

    Not finding what you are looking for?
    Cars & Trucks Logo

    105 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    60792 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6811 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...