Instead of the blinkers automatically blinking when you go to turn, you have to manually switch the blinker arm for anyone to see that you are turning. Can't find the location of the turn signal flashers to replace them. where do i find them?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There is only a few things that can cause blinkers to blink continually, meaning if your saying they wont shut off, Normally it is the blinker flasher or a fuse. Sometimes it can be in the blinker switch itself. I first would check the flasher, and turn signl fuse. If the blinker stays on and does not flash, still can be bad flasher or fuse or a ground problem, You would then have to check the wires around area where there contact to the tail light blinkers and front blinkers. But first start as said earlier with checking flasher fuse, switch and fuse. Mike
When its blinking fast look at both front and rear to verify which bulb isnt flashing. If the right works OK, then the flasher is OK. The flasher is INSIDE the front control module/integrated power module. If you cant find the problem, you may need a dealer to check it.
No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below: Troubleshooting Procedure To start troubleshooting this problem:
Turn the key to the on position (do not start engine)
Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
The simple solution could be the turn signal flasher (which are generally located under the dashboard). Very inexpensive. But you say that smoke was coming out of the turn signal arm. In that case it could be shorted out. To replace the turn signal arm assembly is pretty expensive. Maybe around $200.00 for parts and labor at a shop. Good Luck!