After snow storm put wipers on & they stopped half way up winshield ..I pushed them down & now they dont work at all..is it the fuse or the splin e on the arm or the motor? how or what do i check 1st
SOURCE: winshield washer pump has stopped pumping on 1996
Sounds like pump alright Unbolt tank from car and pump should be screwed to bottom of tank Another way is fit a universal inline washer pump Up to you whether you want to keep your car original
SOURCE: i have audi 14 wiper blades are not working
It is possible that the linkage is jammed. Try turning the wipers on and gently pull the wiper arm by hand to see if it will move. It it starts to move you've found the problem.
If it doesn't move at all and the fuses are ok it is likely the wiper motor that has failed.
SOURCE: audi a3 54 plate .new wiper motor fitted by dealer
The problem is in the wiper switch assembly itself.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
SOURCE: My econ light remains on, on my 04 audi A4.
This is normally one of 3 problems:
1 - Refriant too low
2 - Pressure sensor faulty
3 - Climate Control Unit faulty
In order of cost -
1 - Re gas approx 49 pounds
2 - New sensor - 50 Pounds
3 - New climate control unit circa 700 pound
I have just had the same issue and after a re gas and new sensor it all works okay.
SOURCE: my windscreen wipers have stopped working i have
First you must diagnose why windscreen wipers going slow and/or stopping.
In order to find out the cause of wipers stopping you can try follows: 1. Carefully extract the wiper arms from their axles (two pieces). In some cases you need to use an extracting tool. Heed of the windscreen !!! 2. Disassemble the plastic covers from the bottom of the windscreen. 3. With the bonnet up you can start the engine, (transmission in "N" or "P" position and parking brake on). Now you must switch on the control lever of the wipers, and go to the engine compartment. If the wiper motor runs let the wiper motor running for a few minutes and switch off. Go to the step 4. If the wiper motor do not runs you must check first the electrical feeding of the motor. It is necessary to unscrew three bolts of the mechanism and disconnect the electrical coupling (difficult assurance). If the electrical feeding is OK you must replace the motor - steps 5, 6, 7. If not you must check electrical connections, the control switch of wipers and electric cables. 4. Now you must check the two bearings of wiper mechanism with your hand. In the most cases the left bearing is out of order (is very hot). This is the most encounter fault of the wipers running at Audi. 5. For have enough space to manipulation the wiper motor together with their mechanism you must extract the plastic cover of the engine computer box, and extract also the box screws. Then you can move slowly the engine computer box, just for a few milimeters. 6. You must disconnect the electrical coupling of the motor (difficult assurance), unscrew three bolts of the mechanism and extract together with the motor. You must move them slowly between windscreen and engine computer box until the wiper motor go out together with the mechanism. This is the most difficult operation! 7. Now you can repair the bearings, replace entire wiper mechanism or replace the wiper motor. It is not very simply, but it works.
Heed of the windscreen !!!
Refit all in reverse order.
287 views
Usually answered in minutes!
×