Question about 1997 Jaguar XK8

1 Answer

Traction control warning comes on and it goes into limp home mode

Turn off and wait 5 mins and it goes ok untill the next time ,every couple of days

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 68 Answers

Look at your wheel speed sensors in the back ( this is where I would start)

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes it to go into "limp mode"?


Limp mode is triggered by a serious issue with the cars transmission or engine controls.

Mar 22, 2016 | 2002 Nissan Frontier Crew Cab

1 Answer

Traction warning light comes on at 30mph and puts it in safe/limp mode - can't get faster but also doesn't slow down unless I press the break (even when not touching the accelerator)


Probly a computr issue...dont guess on parts. Unplug it and clean pins..then plug back in..see if car reboots. If no git it scand but find anothr mech. Go to surecritic.com

Jan 13, 2016 | Mini Cars & Trucks

1 Answer

Nissan qashqai engine light plus traction control light come on at the same time and I cant get over 3000 reves


Hi Declan this is called (limp home mode) the computer shuts the vehicle down to half power to get you home. Get to a Garrage and get it diagnosed properly anything more than this is guess work. Regards Jom...

May 08, 2015 | 2010 Nissan Qashqai

2 Answers

Why does my traction control and eml light come on Bmw e46 ?


I'm sorry Roger but you are going to have to get it to someone with access to the plug in diagnostic unit for Beemers.
there seem to be several things going on but when it coughs up the diagnostic info you may go straight to it?

Jun 05, 2014 | Cars & Trucks

1 Answer

Twice now my traction control light has come on, gone into limp mode, engine manegement light comes on, stops but restarts ok,management light clears after couple of hours,


I have had this on B.M.W`s the traction control sensors on the front or rear hubs pack up,the quick way to check this is diagnostics it works cheaper in the long run..Good-luck....

Jan 05, 2013 | Cars & Trucks

1 Answer

I have a 2004 grand prix 3800 engine non turbo. Engine was eratic at cruise with rpms at 1200-2000. rpms would lope 2-300 rpms. I Changed air and fuel filter, and cleaned the throttle body. also checked...


i had a problem with all my lights coming on in my 2006 explore took it to dealer to find out that the battery was dying replaced it and they went away

Mar 26, 2011 | 2005 Pontiac Grand Prix

1 Answer

2003 GMC Sierra 5.3L (has 2004 engine) Drive by wire. Reduced engine power (Limp Mode). Following error codes - P1516, P2135, P0120. Checked all connections at throttle body(Wiggle tested the individual...


CODE PO120 - TP SENSOR 1 SIGNAL RANGE PERFORMANCE. CODE P1516 - TAC MODULE THROTTLE ACTUATOR POSITION PERFORMANCE. CODE P2135 - THROTTLE POSITION SENSOR 1 - 2 CORRELATION ERROR. THIS IS A DEALERSHIP FIX YOU HAVE PROBLEMS OR FAULTS IN THE THROTTLE POSITION SENSOR.

Oct 24, 2010 | 2004 GMC Sierra 1500 Crew Cab

1 Answer

Sluggish acceleration traction light comes on


this must be a 2.3 miller cycle. it is going into "limp home" mode. when this happens, it wont rev over about 3k, and tcs off/tcs lites come on. it feels a lot like fuel cut. probably the check engine lite is also on, and what codes are stored? most common is P1525/26 and 1540, which are the solenoids that control the abv. the abv controls boost, and when this valve is not working proplerly, the pcm stops communication with tcm, and it goes limp home. if you can locate the solenoids, they are on the back of the engine, right next to the egr valve. from right to left, you need to look at the second and forth. you need to ohm them when they are hot. normal is around 26. if they are over 30, or 0, they are bad. there are other possibilities, but this is most common

Jul 03, 2009 | 2000 Mazda Millenia

1 Answer

Engine light problem on 2004 Mitsubishi Colt 1.1


THE COMPUTER WILL STORE A CODE WHEN THE LIGHT COMES ON.THE CODE WILL STILL BE THE WHEN THE LIGHT IS OFF.ANY PARTS STORE SHOULD BE ABLE TO READ THE CODES.

May 06, 2009 | 2006 Mitsubishi Colt

Not finding what you are looking for?
1997 Jaguar XK8 Logo

Related Topics:

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60867 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...