- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the remote start my have still been sending the transponder signal to the computer when you put your key in the ignition it sent a signal to the computer as well which would have given you the problem, all you would have needed to do is open your door wait 5sec which would kill the accessory because you have your door open then start the car with your key
try replacing remote batteries, but must have a second programmed key to reset first one in case its gets uncoded, best advise do not take long time to replace battery, if problem persist have a good honest mechanic inspect door key cylinder security switch if it is not disconnected, but before you do this, if right side front door or rear door has cylinder try opening vehicle from this doors, if they unlock vehicle and alarm doesn't go off you might have problems inside driver's door cylinder switch, on this year vehicle must use STAR SCANNER from chrysler jeep dodge to solve problems
Loosen clamp (1) and disconnect air duct at air cleaner cover (3).
Pry over 4 spring clips (5) from housing cover (spring clips retain cover to housing).
Release housing cover (3) from locating tabs on housing and remove cover (3).
Remove air cleaner element (filter) from housing.
Should say in your manual. If not most can be reset by standing within 2-4 feet from engine compartment and depressing two buttons on remote. Should hear an audible beep or doors should lock. Hope this helps!