Question about 1994 Chevrolet S-10 Blazer
I was on the highway with my 2000 hyundai tiburon. It is an automatic transmission. I was on the highway, I put it in neutral and put it back in drive. Then the sound started. It's really bad. What is it?
Have a transmission shop take a look at it, i agree with 240, you more than likely stripped something in the gearing. you should never shift it out of D when at speed.
Posted on Feb 27, 2009
Tips for a great answer:
Jan 03, 2016 | Hyundai Cars & Trucks
Feb 06, 2015 | Hyundai Motor 2000 Tiburon
following are the general instructions on the start of diagnosing any
electronically controlled engine or transmission problem.
The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM or ECM,ECU), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.
Oct 30, 2012 | Hyundai Motor 2000 Tiburon
The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
Aug 30, 2012 | Hyundai Motor 2000 Tiburon
Jul 20, 2011 | 2003 Hyundai Tiburon
Mar 08, 2011 | 2003 Hyundai Tiburon
Sep 30, 2009 | 2004 Hyundai Tiburon
Sep 04, 2009 | Hyundai Motor 1999 Tiburon
73 people viewed this question
Usually answered in minutes!