Question about 2000 Ford Windstar

1 Answer

Turn signals/flashers not working

Cannot find a burnt fuse. turn signals/flashers not working inside or out

Posted by on

  • Anonymous Mar 29, 2014

    The flashers come on but not the turn signals

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,596 Answers

The FLASHER UNIT ITSELF is Faulty.
The flasher functions for this vehicle are performed by the Front and Rear Electronic Modules.
Front Driver side UNDER DASH

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My turnsignals dont work on my 1987 honda accord flashers do work


flashers and turn signals have separate flasher and separate fuse.

Mar 14, 2016 | Honda Cars & Trucks

1 Answer

What would cause turn signals,and flashers to stop working,and bulbs are good


bad earth to the ofending lights, burnt out flasher unit, worn switch. all assuming youv checked the fuse fisrt, after that check the flasher unit which should be in or near the fuse box and it will look like a rely so make sure youv got the manual or guide book befor you start pulling out the relays

Jul 30, 2014 | 1997 Mercury Mountaineer

1 Answer

Dodge ram 1500 2007 turn signal malfuction


Good job, and good joe to you for solvin it! Now you'll remember that's a common indicator of a burnt out bulb. For some reason I can't explain, that is how a bad bulb acts on the flasher unit - by more rapid clicking (breaking contact inside the flasher relay at a quicker rate). It seems both the front and rear signal lights have to be working for the normal flasher rate ...well good.

Aug 22, 2012 | Dodge Cars & Trucks

2 Answers

Both of the rear turn signals stopped working at the same time, but everything else seems to work. Do you know what can cause this to happen? I changed one of the bulbs and it didn't work.


There is a turn signal flasher under dash...most have a flasher for the emergency signals and one for the turn signals...some have one flasher....but check fuses first...normally it is fuse burnt...if you can locate the flasher normally they will get abnormally warm when bad......it should look like a round or square silver shiney or black cube.........if these are good with ign.on hold turn signal lever down firmly ...if it works replace turn signal unit.....if none of this works you have to troubleshoot wiring...
...normally yellow wire is left turn and green wire is right turn...black or white is ground red is stop light....but normally it is a blown fuse or flasher.

Feb 19, 2011 | 2007 Ford Freestyle Limited

1 Answer

I have a 98 eclipse. I was putting new tail lights on and then the signals stopped working along with the brake lights. the fuse to the brake lights had burnt so I replaced it. The signals however are...


IF THE TURN SIGNALS STILL WORK IN THE FRONT, THAT MEANS THE FUSE & THE FLASHER ARE OK. IF THE SIGNALS DON'T WORK AT ALL CHECK TURN SIGNAL FUSE & STOP / BRAKE FUSE. ARE YOU SURE THE CORRECT BULBS ARE BEING USED?

Jan 24, 2011 | 1998 Mitsubishi Eclipse

1 Answer

Turn signals inside are steady and don't blink. Exterior lights don't turn on at all in rear. Front signals turn on but stay on and don't blink.


this ether sounds like you have bulbs burnt out in the rear, a fuse blowen, or a bad flasher

first check the fuses to see if any are blowen (usually a blowen fuse will lead to this issue)

then replace the bulbs that are not working

replace the signal light flasher (this is usually found in the fuse box in the cabin of the car or mounted to the steering colum)

i hope this helps ^-^



Jul 26, 2010 | 1995 Buick Century

1 Answer

Turn signals and hazard lights won't work. already replaced flasher unit and burnt bulbs but still no turn signals


Check the Fuse box loacted inside the hood. Look for the guidance on the top of the fuse box for locating trun signal fuses.

Check whether they are good. If not replace with correct rating fuse. If the problem is not solved still, wiring harness has to be checked as the bulbs & flashers are replaced already.

Jun 04, 2010 | 2002 Hyundai Accent

1 Answer

Turn signals won't come on inside or outside of car but hazard lights come on inside and outside of car


Check turn signal fuse, if fuse is good, check turn signal flasher, this is identical to hazard flasher, I believe on the 1997 it is located under the dash near the center console. The turn signal and hazard flashers are the same part number so try switching places with them and see if the turn signals work. If turn signals work after switching them you need a flasher.

Nov 09, 2009 | 1997 Chevrolet Camaro

3 Answers

No turn signals or hazzards


first thing is replace both flashers one for signals and the other for hazards. if they still dont work then its your signal light switch, also check all fuses before you do anything.hope this helps.

Oct 20, 2009 | 1999 Chevrolet Lumina

3 Answers

No turn signals


they are seperate flashers. most times they are both on fuse block or clipped along the metal inside edge of the lower part of dash. Don't count on that. if someone changed it once, it could be tucked into wiring somewhere.

Feb 06, 2009 | 1994 Chevrolet Camaro

Not finding what you are looking for?
2000 Ford Windstar Logo

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...