Question about 1995 Jeep Grand Cherokee

1 Answer

95 jeep cherokee it wont stay running at red lights

95 jeep wont stay running at red lights so i changed the plugs and cap and button. and still did the same. the engin light is on and it shows the low coolent and the 02 sensers but i dont know if thats the proplem or not but it runs fine on the highway and street. it only does it at red light and taking off???

Posted by on

  • 1 more comment 
  • chevy696 Feb 18, 2009

    i changed the o2 senser and the coolent temp and it still does it

  • chevy696 Feb 18, 2009

    the pcv elbow it sucking air and very loose

  • the dave May 11, 2010

    Does the O2 Sensor code say that the engine is lean? If so you probably have a vacuum leak.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 188 Answers

Try a tank of supreme gas, plus a can of SEAFOAM in the gas tank.After running about a half of this tank out. Pull positive post off the battery for about 1-minute. This will reset computer, and it might clean up the fuel problems that you are having. If it keeps on, change the O2-sensor out and do the above steps again.

Posted on Feb 14, 2009

  • spankie09 Feb 18, 2009

    Try a tank of supreme gas, plus a can of SEAFOAM in the gas tank.After running about a half of this tank out. Pull positive post off the battery for about 1-minute. This will reset computer, and it might clean up the fuel problems that you are having. If it keeps on, change the O2-sensor out and do the above steps again.

    Did you try this?????

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Grand cherokee will not stay running


cheak the crankshaft position sensor, if that is faulty the car will stall and after a while possibly wont start back up till it cools a bit.I know i just delt with my wifes car would stall at first at a red light or on exit ramp. then it would just stsall driving on the highway.changed the cps and now now problem with that i got another problem now.hope this helps.

Feb 21, 2013 | Jeep Grand Cherokee Cars & Trucks

3 Answers

95 jeep grand cherokee larado 6 cylinder, wont start


Reset the timing and check starter ot see if working. Verify fuel pump is actually pumping fuel.

Jan 21, 2013 | 1995 Jeep Grand Cherokee

3 Answers

Jeep cherokee limited starts and then dies a few seconds after. I have changed the fuel filter, distributor cap and roter, spark plug wires, battery, cleaned the idol controll sensor.. I hear the fuel pump...


If it will start right back up and if you hold gas pedal will truck stay running ? if it will stay running when you hold the gas then replace the idle air control valve it is bad and cleaning it didnt help. but if it wont stay running even if you hold the gas pedal then the first thing is to make sure you are not loosing fuel presure

Jan 12, 2011 | 1991 Jeep Cherokee Limited

1 Answer

Need order to put the plug wires on my 95 grand cherokee


moz-screenshot.pngmoz-screenshot-1.pngGOGGLE JEEP 4.0 FIRING ORDER . CHECK OUT IMAGES PAGE ,ITS ALL THERE.

Mar 13, 2010 | 1995 Jeep Grand Cherokee

1 Answer

92 jeep cherokee wont stay running


Check the fuel injectors and rails for clogging or maybe a seized up ECU. my only other thought is that your throttle position sensor may be shot.

Jul 03, 2009 | 1992 Jeep Cherokee Sport

1 Answer

I have a jeep cherokee 4x4 sport 95 4.0 litre. Wont stay running


check fuses in power distribution center near battery and auto shutdown relay

Apr 26, 2009 | 1995 Jeep Cherokee

1 Answer

I have a 95 jeep grand cherokee and it has 171000 miles and when you start it in the morning it wont stay running unless you keep it running and it runs like its missing but it has new plugs wiers and cap...


Check for codes... pay attention to idle air control, throttle position, manifold absolute pressure and intake temp sensor codes. If not showing codes, these can be tested with a good volt/ohm meter.DO NOT just start guessing and buying stuff!!!

Feb 18, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Occaisional engine misfire, sometime causing engine to stop running


Do a tune up inc, Plugs and wires, if that doesnt work, change the coil packs

Jul 30, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...