Question about 1995 Oldsmobile Cutlass Ciera

1 Answer

95 cutlass ciera wont start, locks work, windows don't

I changed the ignition switch then tested the old one, the old one was fine and so is the new one. Oh well. When we turn the key on, no instrument panel, no radio, no windows. Of course proceed on to try to start not even a bit of noise at the solenoid. The battery is at 12.2 volts. Clean battery terminals. I am guessing another relay or something of that sort. Check fuses at interior. I am generally pretty good at this sort of thing but now I am humbled. Not a hero to my daughter today.

Posted by on

  • bill292 Feb 12, 2009

    THanks but that is the ignition switch! I replaced it.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Located on collum under dash is a box with a harness attached also has a rod that enters it when key is turned the rod should move if this happens try replacing the box it may be bad. the rod is suppose to move and that selects your acc on run and start modes for your vehicle i've replaced a few with same problem

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 olds cutlass ciera 6cyl will not trun over


do you mean wont turn over or wont start. I need to know that in order to explain the process of elimination

Jan 07, 2014 | 1988 Oldsmobile Cutlass Ciera

1 Answer

'93 cutlass ciera 3.3 wont stay on after starting up


ignition module getting warm and cutting of or auto shutoff relay loosing power..

Jan 05, 2014 | 1993 Oldsmobile Cutlass Ciera

1 Answer

91 cutlas ciera 3.3l v6 backfires then stalls but starts back up


SOUNDS LIKE THE IGNITION MODULE OR COIL PACKS HEATING UP

Sep 12, 2012 | 1991 Oldsmobile Cutlass Ciera

1 Answer

I have a 1991 Olds cutlass ciera 3.3 v6, starts up fine when cold/cool. Runs down road fine till warm, then stalls, will not restart. Cranks fine, just won't fire up. You can pull air filter, sprinkle...


Good Evening, you might want to check those injectors, I can not remember for certain but that setup was sequential and when one or two have a problem it would take out the rest. Ohm out the injectors and see what you have there.

Nov 03, 2010 | 1991 Oldsmobile Cutlass Ciera

1 Answer

95 olds cutlass ciera,31,000 origional miles is cutting out .


check air and fuel filters most likely the fuel filter and possible tune-up

Jan 13, 2010 | 1995 Oldsmobile Cutlass Ciera

1 Answer

95 olds cutlass ciera 3.1 v6 torque contverter lock up (or seems to be rpm increases) disengages on highway speed what is the cause or defects that you may know?


Could be TCC lock-up switch faulty. Trany pump might be going out. New torque converter? If you have put a new converter on an old unrebuit trany the old cruddy fluid will contaminate the new converter and could cause pump failure. This can happen vise- versa too. New trany with an old converter will wreck the new trany with left over old trany fluid. Check to see if there any codes being set. A local parts store can check. Call you local dealer to see if it is a known issue or recall.

Aug 13, 2009 | 1995 Oldsmobile Cutlass Ciera

1 Answer

Ignition lock 1994 cutlass ciera


You need a new ignition lock cylinder. One of the tumblers inside probably broke.

Aug 04, 2009 | 1994 Oldsmobile Cutlass Ciera

3 Answers

1991 olds wont start


I have no spark. Changed the CSS and still no spark. I also changed the Coil packs with a junk yard 1. Does anything else control spark other then ECM?
Thanks

Dec 18, 2008 | 1991 Oldsmobile Cutlass Ciera

1 Answer

The windows in the 95 oldsmobile cutlass ciera won't work at all


maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.

Oct 04, 2008 | 1995 Oldsmobile Cutlass Ciera

1 Answer

Ignition won't turn to start the car


the lock cylinder may have to be replaced, have you tried moving the steering from side to side while trying to turn the key, if you do need to get a new ignition lock cylinder have a lock smith key it to fit your old keys

Jul 30, 2008 | 1991 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
1995 Oldsmobile Cutlass Ciera Logo

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...