Question about 2007 Chevrolet Silverado 1500 2WD

1 Answer

2007 Chevy silverado 1500 4.8 wont start

Took down oil pan changed gasket put every thing back together wont start? turned key to on and you can here the pump send gas? Sprayed quik start in the air intake and nothing?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

If you had to loosen the engine mounts and raise or lift the engine to gain clearance you may have accidentally pulled apart an electrical connector or cracked the distributor cap when it hit the firewall. good luck

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Done an alt. change after doing a tune up truck ran than just shut down now will not start


Truck ' DIY Forums

www.diyforums.net/truck-2418/
My 2003 chevy Silverado V6 truck turns over but will not start..it acts lik. ... iS IT HARD TO REMOVE AN OIL PAN ON A 4.3 VORTEC S-10 PICK UP TRUCK ...silverado 1500 ext. cab. my problem is while driving on the highway my truck ... mytruck then took off the terminal to see if the alternator was work and now i have no .

Chevy Silverado and GMC Sierra Stalling Problem - Car Forums at ...

forums.edmunds.com > GMC > GMC Sierra 1500

Apr 4, 2008 - 30 posts - ‎22 authors
I can feel the truck hesitate or bump while changing lanes on the highway (70-80 MPH) if it ... Now it idles ... My truck has a 4.3 with automatic. trucks runs great after about a hour it .... It will idle and drive just fine, but will simply shut down. ... the not firing problem, but shuts off after it finally decides to start. Chevy Silverado and GMC Sierra Gasoline Engine ...
30 posts
Jun 14, 2010
Chevy Blazer Fuel Pump and Pressure Regulator Problems
30 posts
Mar 10, 2010
Chevy S10 - GMC S15 and Sonoma Stalling/Dying ...
30 posts
Dec 14, 2007
Silverado starting problem...
30 posts
Nov 15, 2007
More results from forums.edmunds.com

Dec 26, 2015 | 2004 Chevrolet Chevrolet Silverado 1500...

1 Answer

Replaced oil pan gasket on and now oil is pouring out when the engine is off


Did you use a torque wrench on the pan bolts? They have to be set to inch pounds of torque, if you over do it or under torque it, there are problems.

Feb 17, 2014 | 2000 Chevrolet Silverado 1500

1 Answer

Took my 2007 chevy uplander to a mechanic to change oil pan gasket. now he is telling me my transmission is gone. it was running fine when i took it to him. did he do something wrong when changing the...


I would advise getting a second opinion A mechanic told me my 92 Le sabre 's tranny was shot and when I took it to another mechanic he found my spark plug wires were shorting out and causing the car to down shift when you went up a slight incline and it would jump in and out of different gears. I replaced the plugs and wires myself and it rau like new.

Jan 16, 2014 | 2007 Chevrolet Uplander LS Minivan

1 Answer

I have a 07 Chevy Silverado w/ 5.3L. I presently have 105k on it and have noticed that in the last 12 months, my oil consumption has increased dramatically. Following the oil life monitor since my last...


double check for leak at rear of engine where engine block mates the transmission .the housing for the rear seal is bad about leaking on these engines at 100,000 miles

Dec 25, 2010 | 2007 Chevrolet Silverado 1500 2WD

1 Answer

Oil leaking on my mufflers of my 85 c10 chevy silverado. and i already changed the oil pan gasket


it could be a few things oil sending unit /intake gasket/valve cover gasket/ rear oil seal /I would wash the engine and look starting from top down

Mar 30, 2010 | 1983 Chevrolet Silverado

1 Answer

Know how to change the oil pump in my 1997 chevrolet SILVERADO?


The oil pump is in the the oil pan so you will need a new oil pan gasket and some form a gasket as well to put the pan back on, because you will have to take it off, you will see the oil pump a soon as you take the pan off, it will have a tube connecting to the pick up screen and to the block, remove bolts from the block and remove oil pump. be prepared the primming rod will probably come out too. itll need to go back of course, make sure seated in correctly because the primming rod runs off the cam. make sure the surface area for the oil pump gasket is clean before reinstalling new oil pump same goes for oil pan. after everything back together refill oil. It is best to test the oil pump before starting for your engine. the best way to do this is to remove the distrubuter if it has one if it has electronic ignition it will have a cap where the distributer went remove that and you will see the top end of the primming rod, fit appropriate socket on the primming rod and use a battery gun to spin, look inside oil fill cap and make sure you see oil flow or oil pressure on your gage if equiped, CAREFULL!!!!!! make sure the socket on battery gun has no way of falling off, or you will have to remove oil pan again to retrieve it.
Another way to prime pump is to disable igniton main power like remove the coil wire, or main power wire for electronic igniton so you can turn the motor over with out it starting, once again turn it over until you know you have oil pressure with the gage or through oil fill cap. put ignition back together start the car and once again confirm oil pressure. If every thing looks good your done Good luck

Mar 20, 2010 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

Does my chevy silverado 2004 v8 2wd ls transmission have a filter and drain plug


No drain plug, the filter is inside trans. Remove trans oil pan (it will be full of tran fluid so loosen bolts on one end and work your way to other end) May have to take bolts out of a cross member and slid it back to get to all the pan bolts. The filter is flat and you'll see it once the pan is dropped. Pull straight down to remove. Clean out sludge and old fluid from pan and scrape old gasket off.
Push new filter into place. Its a good idea to use gasket sealer to help keep it from leaking and to help hold gasket in place so bolt holes stay lined up while bolting up pan. Tighten all bolts evenly. Then refill tran with the fluid your service manual list. Operate your truck in all gears (shifting back and forth) and recheck trans fluid level. Its not a hard job to change filter and fluid. If you can change your own motor oil and have a rachet and sockets then you couldnt have any problems. Just get your filter and trans fluid from your local auto parts store like Autozone or Advance Auto Parts.

Mar 12, 2010 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

I have a 1999 chevy silverado 5,3 i had the oil changed three weeks ago. now my light comes on tellin me to change my engine oil. what could cause this?


  • its a sensor that lets you know to change oil. 1st turn key on start possession don't start, 2nd pump gas pedal three times fast not real fast then after the third time turn key back to off then start the vehicle this should reset the light!!

Mar 31, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Changed oil pan gasket now i dont have much oil pressure


If oil pressure was fine before you changed the gasket, it's likely that some debris was loosened up (probably under the pan baffle) and got onto the oil pump pickup, restricting flow. The only other cause of low pressure would be worn engine bearings, which would not happen just by changing oil pan, unless you messed with either bearings or pump while pan was down. Remove the pan and carefully inspect the pump pickup for debris!!! DO NOT DRIVE VEHICLE 'TILL YOU HAVE CORRECTED THIS OR YOU WILL DAMAGE BEARINGS!!!

Feb 19, 2009 | 2000 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

289 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...