Question about 1999 Mercury Villager

2 Answers

Mercury Cougar heater blower only works on high.

1999 Mercury Cougar heater blower only works on high. Put in new switch but did not fix problem. What should I try next?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Mercury Master
  • 783 Answers

Remove the trim panel below the glove box and you will see the blower motor,just to the left of it you will see a 4 wire connector plugged into the case. This is the blower motor resistor,this is what you need to replace.

Posted on Feb 12, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Replace blower resistor behind glove box in heater duct.

Posted on Jan 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The motor stalls when the heating direction knob is turned on


2002 Mercury Cougar V6 2.5L problem - YouTube

? 2:28
https://www.youtube.com/watch?v=zUu256ADwJA
Jun 2, 2012 - Uploaded by 1chrisrg
U know how to adjust idle speed manually on 2000 mercury cougar? ... You may drive and the hole is too small and the coug will stall. .... I replaced the IAC and now if sounds like my engineis in a race ... I just bought a 99 Cougar. ... new edge cougar owners forums and I believe there are directions on ...

How to replace heater control panel switch knobs remove ...

? 5:01
https://www.youtube.com/watch?v=abBINs_zWh8
Jul 12, 2013 - Uploaded by kirk colombo
02 explorer - remove dash panel and replace heater and air conditioning control switch knobs. Can also ...Missing: cougar ‎stalls

A/C & Heater Controls for Mercury ' eBay




Dec 13, 2015 | 1999 Mercury Cougar

1 Answer

1993 Mercury Cougar Low beam headlights are out


Did you try new bulbs? Next check your dimmer switch on column

Nov 29, 2011 | 1993 Mercury Cougar

1 Answer

My a/c went out on my 99 mercury cougar but that was because my a/c compressor went out. My heat was working after that and then it went out too. I thought it was my blower motor so i bought a new one....


You have two other components that control the blower, the control switch and the blower resistor block. The switch is the knob you turn to select the speed and will cause you loose power to the next component that is the resistor block. This part is usually next to the blower motor because it needs to be cooled by the fan and it is responsible for the different fan speeds. Either component can cause a total loss of the blower fan. Go to a online parts lookup like autozone.com and it will show you a picture of the parts so you can identify them.

Mar 03, 2011 | 1999 Mercury Cougar

3 Answers

A/c and blower does not work i have 14 vots to the fan but still wont work


If it has power you need to confirm if it has a good ground. If it does it may be a defective motor. If not it may just need a blower resistor or have a wiring problem.

May 19, 2010 | 1999 Mercury Cougar

1 Answer

1999 mercury cougar. 3 of my 4 blower settings for a/c stopped working 6 weeks ago and today the 4th went out. i had the blower test and is fine. I replaced the blower resistor and blower switch and still...


Make sure you contact a Mercury Dealer or Ford Dealer and run your vehicle ID number to see if it has a recall on the blower switch. I worked for Ford for years and I think I remember that vehicle having a blower switch and or relay recall. Some of these recalls did not expire and if that is the case it would not cost you anything to have this done. Good luck, hope this helped

Feb 06, 2010 | 1999 Mercury Cougar

1 Answer

My heater will not turn on


if the blower motor won't turn on try replaceing the blower motor resistor located on the heater box under the hood

Jan 13, 2010 | 1996 Mercury Cougar XR7

1 Answer

Blower motor fuse is located 99 mercury cougar


SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.
-------------------------------------------------------------------------
f9d16f6.gif

May 06, 2009 | 1999 Mercury Cougar

1 Answer

A/c or heater not working


you may have to reprogram pcm. there is a TSB on this. call dealer to confirm

Mar 12, 2009 | 1999 Mercury Cougar

1 Answer

99 cougar heater


I had this exact problem, it is probably your Blower Motor Resistor. It is located under/behind your glovebox, one screw holds it in. Not too expensive either. If that doesn't work it may be your blower motor. Good Luck!

Nov 20, 2008 | 1999 Mercury Cougar

Not finding what you are looking for?
1999 Mercury Villager Logo

853 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...