Question about 2002 Mazda 626

1 Answer

Interior button no longer pops the trunk

How is the system fixed to allow the interior button on a 2002 Mazda 626 LX to pop the rear trunk again. Thanks.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I believe there is a switch in the trunk compartment to the left hand side that enables this button to function check that out....

Posted on Feb 12, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2008 Cadillac CTS push button to open trunk sometimes works

Do you know anything about automotive electronic's ? The trunk release is controlled by electronic control modules . Having the vehicle check for DTC'S - diagnostic trouble code's should be the first step in the diagnostic procedure . Then reading how it work's !
Factory service repair info.
Rear Compartment Lid Release System Components
• Body control module (BCM)
• Remote control door lock receiver
• Interior rear compartment lid release switch
• Exterior rear compartment lid release switch
• Rear compartment lid release actuator
• Trunk release relay

Rear Compartment Lid Release Operation
The interior rear compartment lid release switch receives a signal from the driver door switch assembly (DDSA). When the interior rear compartment lid release switch is activated, the signal circuit is pulled to ground. The DDSA interprets this and sends a GMLAN serial data message to the body control module (BCM) requesting the rear compartment lid be released. The BCM responds by applying battery voltage to the trunk release relay control circuit which energizes the TRUNK RELES relay. The trunk release relay is supplied with battery voltage at all times. With the relay coil energized, the relay switch contacts close allowing battery voltage to flow to the rear compartment lid release actuator causing the rear compartment lid to release. The rear compartment lid release actuator is permanently grounded at G402.

The trunk release relay is located in the rear fuse box located under the back seat.

Dec 23, 2017 | Cadillac Cars & Trucks

1 Answer

My 2002 Lesabre lost interior lights, trunk release and rear defroster at the same time. Body fuse is not blown. W

What body fuse ? The body functions on your vehicle are controlled by three different control module . The IPM - instrument panel integration module ,the DIM - dash integration module an the RIM - rear integration module. Having the vehicle scanned for DTC'S - diagnostic trouble code's should always be the first step in a diagnostic procedure for this type problem . Not at auto zone or advance etc.... they can not pull code's from the body computers . When you push the button for the rear defroster ,trunk release ,these are input's to one of the front modules which will send a message over the class 2 data bus to the rear module which will energize a relay to pop the trunk or turn on the rear defroster . The rear module also controls the interior light's . Your best bet , take it to a qualified repair shop.

Nov 24, 2017 | Buick LeSabre Cars & Trucks

1 Answer

Locks wont stay locked

there is a fuse in the fuse panel under driverside dash. alternate is to use the "deactivate remote entry" button in the trunk. it was designed to increase security for valet service. the bummer is you'll have to lock/unlock doors and trunk manually with the key

Sep 11, 2013 | 1995 Mazda 626

2 Answers

1998 buick park avenue. My interior lights not working, no power to ac compressor, trunk button not working, no power to cooling fans, rear defroster, and voltage meter reads ???? ALL Fuses are good!...

Some vehicles have a primary fuse box under the hood, these have heavy duty 20-60 amp spade fuses, usually located close to the battery, some supply sections of the interior fuse panel, if you pop one of these a lot of things will not work, hope ill fixya

Dec 26, 2012 | Cars & Trucks

1 Answer

Check engine light on for 2 years

have light cked and repair problem interior light could be fuse switchs or light its self.

Aug 05, 2012 | 2002 Mazda 626

1 Answer

Change break light

start by opening the rear gate (deck lid / trunk / boot) and using a small pointed tool , pop out the center of the retaining clips to loosen them to allow access behind the interior trunk liner.
This should allow you access to the rear of the tail light and the bulb holders / sockets to change the lights.
Do it right and replace all of the lights right away , keeping the old un-burnt bulbs as emergency spares.

Jul 15, 2010 | 2000 Ford Focus

1 Answer

How do you remove the rear taillight assembly on a 2002 Mazda Millenia

you start by removing any interior panels in the trunk to gain access to the light. Usually this includes the piece that runs across the rear body panel. this will be where the trunk latch is. after this is out the side will pull toward the middle of the trunk and you should see four nuts to remove and a plug to disconnect and then the light will be ready to remove. good luck

May 18, 2010 | 2002 Mazda Millenia

1 Answer

2002 Mazda Tribute rear liftgate lock replacement

I'm not sure where' the screws are but basically You need to remove the panel on the rear door, then once the panel (interior trim) has been removed you should see a lock mechanism which will be screwed/bolted in place. Easier and cheaper then buying a brand new lock mechanism (unless you want to buy brand new) is going to a wreckers and finding your car model and get it that way (yes it's used but it'll probably save you tons of money vs the dealership) Best Regards.

Nov 22, 2009 | 2002 Mazda Tribute

1 Answer

How do you replace the interior light in a Mazda 1990 626

it should just pop out has little edges .Need more go to Collsion

Mar 09, 2009 | 1990 Mazda 626

1 Answer

Engine will not turn over

sounds as tho the battery is dead or dying... get a boost and see if that starts it.


Feb 05, 2009 | 2002 Mazda 626

Not finding what you are looking for?
2002 Mazda 626 Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8830 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides