Question about 1992 Ford F250

1 Answer

Abs light stays on

I have a 1992 ford f 250 i just replaced abs censor in rear end but abs light wont go out what can i do

Posted by on

  • Anonymous Mar 24, 2014

    Brake light stays on changed discs pads and offside rear abs brake censor

  • Anonymous Mar 30, 2014

    Light stays on

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 161 Answers

I believe you have to have the computers code cleared....try unhooking the battery for 10 minutes......that should clear out the computer.....if not bring to autozone or the local shop that runs odbc2 and tell them to clear the code.

Posted on Feb 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Are the brakes on the 1992 f-250 abs?


Yes it has a minimum of Rear ABS and 4 wheel ABS was avail.

Dec 12, 2010 | 1992 Ford F250

2 Answers

My abs light stays on on my ford focus


when the ABS light stays on it means there is a fault present in the ABS system and the ABS has been disabled, as long as the light is on u just have regular brakes with no ABS, there are many thinbgs that can turn the light on, most common is one of the wheel speed sensors is defective, since these sensors are about $75-100 each and there are 4 of them guessing is a poor idea, so what u need to do is have the ABS systwem tested, there will be a fault code present to help narrow down the defective part or wiring.

Dec 28, 2009 | 2004 Ford Focus

1 Answer

The ABS light stays on and the Overdrive light on the gear shift flashes on my 1999 250 Super Duty.


Same problem with my '99 Super Duty. The speedometer was also malfunctioning. Replaced the ABS sensor mounted on the rear transaxle. Costs approx. $30 and fixed the problem.

Aug 03, 2009 | 2008 Ford F-250 Super Duty

1 Answer

1992 Honda Accord EX Replacing the Rear Wheel Assembly


It won't make any difference, seeing that the car is older and you don't have the ABS functionable it won't change anything. You already have the ABS light on so nothing new will happen.
Regards
Sam

May 05, 2009 | 1992 Honda Accord

1 Answer

Abs light wont go out


When u power up the vehicle ABS does a self test(light stays on a few seconds then cuts off) and if it see's a problem will shut off and illuminate the ABS lamp. It will also do a second test on iself when you reach a speed of around 12-15 mph,it will run the pump for a few seconds to check pressure and look at the speed sensors,if it see a problem here it will again shut down and illuminate the ABS light.
Now if the red brake lamp is on then it will shut down because it thinks you have a hydraulic concern and will not try and run ABS if this is the case.
If red brake lamp is on most likely if you have good brakes it is a problem with the float sensor in the master cylinder reservior,maybe its bad or just stuck,or just low on fluid.

Feb 12, 2009 | 1992 Ford F250

2 Answers

Rear end roar


I have heard of the 8.8 rear ends premeturely wearing out. Did you buy this car new or used? If you bought it used, you never know how the previous owner drove the car. Remove the rear cover and inspect the oil and gears inside. If the oil smells burnt, the rear end is most likely junk.

Jun 19, 2008 | 2002 Ford Explorer

Not finding what you are looking for?
1992 Ford F250 Logo

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...