Question about 2004 Infiniti I35

1 Answer

Power seat motor replacement

Need to know how to remove seat on 92 merc cougar & replace the motor ---drivers side

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 333 Answers

You need to remove the 4 or 8 bolts that hold the track to the floor. Then you can remove the seat. But you must unclip the wires for the motor first before removing it so you do not damage them. I hope this helps. Don't forget to rate my answer, thanks.

Posted on Feb 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the location of the fuel pump driver module on a 2001 mercury cougar


This module is located behind the interior side trim panel, LH side behind the front seat, below the rear LH side glass. AKA B Pillar trim panel. Access from inside, probably will require removal of the rear seat bottom and even top of seat to remove the panel. it will be the small box in the center of that area once the panel is removed. Good luck!

Sep 20, 2014 | 2001 Mercury Cougar

1 Answer

CANT FIND RELEASE TO REMOVE BACK SEAT FROM 2000 MERCURY COUGAR


You have to push down real hard with your knee on the front side of the back seat and at the same time with your hands, push the seat back towards the trunk..You have to do the same thing on the other side.(two wire locks one on drivers side and one on passanger side).
Hope you understand this???

May 22, 2011 | 2000 Mercury Cougar

1 Answer

On the coil its self what is the firing order plug location I know the motor is 1-4-2-5-3-6 but where they go on the coil i dont 1999 merc. cougar 2.5 v-6


cylinder firing order on 1999 mercury V-6 engine is 1,2,3 on the passenger side starting from front to back. on drivers side engine cylinder is numbered 4,5,6 starting from front to back.of course you already know the distributor firing order sequence.

Jan 16, 2011 | Ford Thunderbird Cars & Trucks

3 Answers

What fuse controls driver side power window?


If the other window works fine then it is not your fuse. Chances are that your driver's window has an "auto down" feature. There is a relay inside the driver's side door that controls this feature. If the relay is bad then the window will not work. Solution 1) replace the relay. It cost about $50 from the dealer. Solution 2) remove the wire harness from the relay and "jumper" the plug to bypass the relay...this will allow you window to go down, without the "auto down" feature.

Jul 08, 2009 | 1999 Mercury Cougar

1 Answer

1998 Cougar power seat works in all directions except forward


THE MOST COMMON CAUSE OF THIS IS THE SEAT SWITCH (WIGGLE THE SWITCH WHILE YOU TRY TO MOVE THE EAT), IF THAT DOESN'T FIX IT U WILL NEED TO REPLACE THE POWER SEAT TRANSMISSION, A VERY EXPENSIVE PART, SO TRY THE SWITCH 1ST.

Jul 06, 2009 | 1997 Mercury Cougar XR7

1 Answer

Engine monts


Normally you put a floor jack under the engine front or flywheel with a 2x6 cushion board attached and jack it up an inch or so to releave the pressure on the motor mount. Then with mechanic tools and wrenchs remove and replace the motor mount.

May 10, 2009 | 1988 Mercury Cougar

1 Answer

Drivers side electric seat only moves on left side


hello i have a 92 olds ninety eight and my back on the drivers side seat want let back up its it the max down position.

Mar 18, 2009 | 2003 Oldsmobile Bravada

2 Answers

1993 Mercury Cougar power window, driver side, will not move


It could be one of about 3 things, the switch could be bad, the motor, or the window regulator. Sometimes you can hit the lower part of the door a couple of times wile holding the window switch to check the motor. I don't know how to check the switch but the cable on the regulator can brake and wrap around the motor not allowing it to run. The only way to check this is to take the door pannel off and see if the cable is broke.

Jan 01, 2009 | 1993 Mercury Cougar

1 Answer

Seat belt chime will not stop until ignition is turned off. mercury cougar 92


the wire under driver seat must have coom loose from the seat belt clip

Dec 04, 2008 | 1992 Mercury Cougar

Not finding what you are looking for?
2004 Infiniti I35 Logo

1,418 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13567 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...