Question about 1993 Chevrolet Lumina

1 Answer

1995 chevrolet lumina van : replace the crank cenensor

The car runs well at the beginning an then proceeds to hesitate and run rough and cuts off. cranks fine every time.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 491 Answers

What is the question

Posted on Feb 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1990 Chevy Van with a 350 small block that has a mind of it's own.

Try to get it running a bit to warm up the exhaust. Take a point and shoot thermometer and take the temp of the cat. If temps exceed 400 degrees I would start to suspect a plugged cat.

Mar 05, 2017 | Chevrolet Cargo Cars & Trucks

1 Answer

How to replace a crankshaft sensor in lumina van apv 1995 3.8

It's not really something u can do in your driveway if u don't know much about cars but this will help ya out take off sepentine belt with 15mm wrech at the tensioner take off passenger side tire u will need to take off the crank pully the big one at the very bottom bolt Is roughly a 7/8 head no the bolt u will need a crank pully puller and the sensor will be on the right an u will need a 10 mm socket to remove it good luck

Jul 21, 2011 | Chevrolet Lumina APV Cars & Trucks

1 Answer

96 Lumnia van 7 psi before cranking. Hard to start but when running has 35 psi. Why is the psi so low when it needs higher to start?

i would suspect a high resistance in the cable or the earth ,check voltage to pump when cranking engine as a first step

Jun 14, 2011 | 1995 Chevrolet Lumina Apv

1 Answer

Where is the crank censor locate on a lumina van 1995

Hi, it is on the rear of the engine just below the middle spark plug just above the transmission oil pan

Nov 27, 2010 | 1995 Chevrolet Lumina

1 Answer

I have a 1995 chevy lumina 3.1 and upon starting the engine will either hesitate and die or it will idle and when i press the accelerator it hesitates and then the engine dies...what could this be?

you need a tune up...plugs, possible wires too, they might have a lot of carbon tracking deposits on them ...clean (IAC) sensor, if you"ve never cleaned it, believe me it"ll be dirty.. and then make sure you completely clean you throttle body too inside and out! but wait an hour after before starting to let it air dry...clean air filter or replace it, and replace fuel filter if it hasn"t been replace in a long time. also after you"ve done this purchase a can of Sea Foam fuel system cleaner $10 and pour 1/2 can into 1/2 tank of gas and drive around even if its running "a little rough", for about 30 minutes and this should clean out any fuel injectors that may be possibly clogged up! if you you cant drive the car but will idle only after cleaning (idle air control), pour some seafoam in the tank and let it idle for about ten minutes then try to see if it will run. If none of this works then you probably have a fuel pump not putting out the correct pressure!

May 16, 2010 | 1995 Chevrolet Lumina

2 Answers

Astro Van is running rough

No,the oil ratings 10w30 and so refer to how the oil viscosity reacts to hot and cold.As far as running rough,when was the last time is was tuned up,cap and rotor if applicable,spark plugs and air filter?Is it carburated or EFI?

Apr 13, 2009 | 1995 Chevrolet Astro

1 Answer

1995 Chevy Van Cannot start after shutting it off without jumping

Check the crank sensor probably when you replaced the timing belt you could have either not put the crank signal ring in correctly or damaged the crank sensor.

Mar 25, 2009 | 1995 Chevrolet Lumina Apv

1 Answer

1995 chevrolet lumina van 3.1 will crank over but will not start

well try putting the old brain back to see if still does the same thing because sometime u cant use the brain(pcm) from another car becuase they have to be programed for that car

Jul 13, 2008 | 1995 Chevrolet Lumina

Not finding what you are looking for?
1993 Chevrolet Lumina Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides