Question about 1990 Chrysler New Yorker

1 Answer

Car wont start.1990chrysler newyorker 3.3 my car will not start.replaced switch,tested starter still nothing.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 76 Answers

If it will not crank have you checked all your fuses and relays? there should be a crank fuse and a starter relay. is the relay functioning propperly. next check at your starter yould should have a larger wire that is hot or has voltage on it at all times directly from the battery. there should be another smaller wire that comes from the ignition and at the keys crank position you should get 12volts on this wire this is what energizes your solenoid on the starter. not sure if you have already checked this hope it helps

Posted on Feb 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car warms wont start


READ THIS ALL BEFORE YOU DO ANYTHING
NOTE: some vehicles have the starter relay and starter mounted together as 1 unit. Sometimes the starter relay and starter are seperate. When I refer to "relay" it could also mean the starter and relay as 1 unit.
Note: "starter switch" is not to be confused with "key switch", although sometimes they are all one unit. The starter switch is usually mounted on the steering column and actuated by a metal rod. On units that are all one unit, the keyswitch/starter switch (both one unit) will have to be replaced. (this is a rare problem, so don't get worried just yet)
1. Check battery voltage, should be between 12.5-14.5 volts. if low voltage replace or charge battery, and try to start car, if it don't crank with new or charged battery, move on.
2. Check connections on the starter relay, even the small one coming from your starter switch. if loose or corroded, clean with a brush and reconnect them. Try to start your car. Did it start? if not, Move on
3. Well now we know the connections aren't the problem. How about a click? did you hear one? If a click is heard, go to #4, if nothing is heard, go to #5
4. Well at least the relay is clicking, but nothing else is going on. The relay is working, so the starter must be bad. Replace the starter and start your car!
5. Humm, connections aren't the problem, maybe the relay is bad, replace your relay with a new one. Move on
6. Now we have a new relay, with clean and tight connections. Start your car. Does it start? If yes, then HORRAY! we fixed it. Does it click? If so then goto #7, If it don't click, then goto #8
7. So here we have a new relay, with good connections that will click when trying to start the car, but nothing else happens. Starter is faulty, replace the starter, and off you go, see ya!
8. So here we have a new relay, with good connections, but it still won't click when we try to start our car. This means that your starter switch is faulty. Replace starter switch and try to start your car. Vroom! finally done with this car problem!
List of shortcuts: if you remove the starter switch lead (small wire) from the relay and apply +12v to its respective prong or lead on the relay, and your starter cranks, your starter switch is faulty. You can actually hook up a starter button this way. If you jump the two large wires together on the relay and it cranks, then the relay is faulty. If you jump the two large wires together and nothing happens, then starter is faulty, or wires to starter are loose or broken.

Dec 12, 2013 | Geo Tracker Cars & Trucks

1 Answer

My 2005 suzuki aeiro wont start.battery is good . wont turn over


what transmission,?
this can be 3 things, if it wont jump and batter is good.
bad connections at battery or starter.
1: bad starter.
2: bad (A/T shift switch) or bad M/T clutch switch.
3 bad ignition switch.
4: bad wire or connections end to and start system.

hot wire the starter solenoid, if car starts (cranks) then its 2 o 3.

Apr 07, 2013 | Suzuki Cars & Trucks

1 Answer

My 2008 dodge caravan wont start turn the key and nothing thought it was the starter. removed it and tested. tested ok put starter back in and hooked up a remote starter switch starter turns over now with...


You need to proof read your problem, confusing. Motor turning over and one starting are different. Is the remote factory? If not you need to disconnect the power to it and try again.

Feb 01, 2013 | 2008 Dodge Grand Caravan

2 Answers

Car wont start: 1. Had it tested technician sad


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks

Jun 23, 2010 | Cars & Trucks

1 Answer

Wont start--pulled starter bench tested ok


check your ignition did one of these before changed 3 starters before finding out it was ignition switch not making connection in switch good luck

Feb 07, 2010 | 1997 GMC Jimmy

1 Answer

Why wont my 2000 sunfire start?


starter relay,ignition switch,park switch.need to use a volt meter and start at the starter,see if you have at least 12 volts.if there is have the battery tested.does your head lights come on?next no voltage, go to the fuse box under the hood and check for (2) 12 volt powers with the key on and a good ground.if ok replace the relay.next move the trans shifter to neutral with foot on brake and try and start if it starts you need park switch.if not next is the ign.switch to test,you will need to locate the starter wire and check for voltage when starting if none replace the ign.switch hope this helped.also the alternator has nothing to do with the cranking of the engine on this car.

Nov 25, 2009 | 2000 Pontiac Sunfire

3 Answers

Wont Crank


im thinking its the starter..i would take it out and brin it into like an autozone they test them for free..

Oct 24, 2008 | 1995 Jeep Grand Cherokee

2 Answers

Van wont start


check the small connector at starter for voltage when cranking if ok try the hammer test if starts bad starter (ie) tapping starter with hammer while trying to start.

Aug 26, 2008 | 1992 Plymouth Voyager

1 Answer

My car wont start


sounds like a starter promblem smack the starter with a hammer a few times then try it if it starts you have a short in the arnuture replace the starter

Jun 03, 2008 | 1994 Oldsmobile Achieva Special Edition

Not finding what you are looking for?
1990 Chrysler New Yorker Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...