I think it's the relay in the main fuse box, but i don't have the layout. can i get a layout diagram of the main fuse box (in the engine compartment)? The wiring continuity to both front fog lights is good. The rear fog light works correctly. The front fog fuse is good. All connectors look new, so no corrosion. The light stalk on the steering wheel is Type B.
Both fuse and relay are located in engine compartment fusebox.
Click the link below to go through fuse box diagram:----http://schematicsdiagram.blogspot.com/2013/02/nissan-fog-lamp-relay-and-fuse-box.html
-------
This will help.
Thanks.
SOURCE: Wiring front fog lights to a 2002 freelander ES.
Do not fit these lights yourself,you must take the vehicle to the dealer to have it done .Firstly as vehicle wasnt factory fitted you need the original homoglonation certificate from the manufacturer for the model with the foglights fitted,then you need a installation project drawn up by certifide auto engineer with the relevent technical qualifications (i have them) then they can only be fitted by a garage with an added value tax certificate,then vehicle must be presented to the local vehicle inspection depot to be mechanically inspected all over weither its due or not,the relevant paperwork plus the fee presented ,then a new vehicle registratrion document issued showing the changes.Failure to to this will cause the vehicle to fail its inspection when next presented as paperwork isnt correct ,the lights are ilrevelent as to weither they work or not,but if fitted from new they must work.Also if stopped by the guardis civil and paperwork checked,and they notice then you risk having the vehice impounded their and then on the spot ,big fine and the cost of the removal truck.
SOURCE: need a fuse box diagram to wire in fog lights
Fog lamps are installed on the front bumper. The switch is located
to the left of the steering column on the dash panel. The fog lamps are
turned off by the circuit relay when the high beam driving lamps are
turned on. The circuit relay is located on the right front wheelhouse
panel near the blower motor.
Good luck, and remember rated this help.
Removal & InstallationFog Lamp Element
See Figure 1
Fig. 1: Exploded view of a fog lamp assembly
DO NOT handle elements with your bare hands, always handle with a
clean cloth. Oil from your hands will cause the element to fail.
Fog Lamp Switch
The fog lamp switch is removed and
installed by simply prying the switch from the instrument panel and
unplugging the electrical connector.
FOGLAMP BEAM ADJUSTMENT
1995 Cherokee Chassis Schematic
www.autozone.com
SOURCE: fog lights will not work on 2001 jeep wrangler
check your grounds on your fog lights make sure they have a good ground.GOOD LUCK.
SOURCE: Wiring for Bosch Hologen Fog Lights? Wiring
Look on the relay for the terminal numbers.
Terminal 30 goes to the battery positive.Red Wire
The two terminal 87 go to the fog lights.Black Wires
Match the color wire with what you have on the relay connection for the rest of the wires.
Terminal 86 should connect to your low beam headlight.
Terminal 85 should go to the fog light switch.
The fog light switch should connect to the terminal 85 and the other terminal on the switch will connect to ground.
SOURCE: 1998 Ford Escort dashboard warning lights and gauges not working.
Sounds like possibly the ignition switch is going out. Try jiggling the key in the ignition in the on position and see if your lights come back on.
2,490 views
Usually answered in minutes!
×