Question about 2005 Jeep Grand Cherokee

1 Answer

Heating and air conditioning

The heat and air conditioning on my 2005 Jeep Grand Cherokee only works in the high setting. Any thoughts?

Posted by on

  • Anonymous Feb 11, 2009

    so it is in the interior? Not under the hood.Ok i will check.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 475 Answers

The blower motor works on high setting ONLY when the blower resistor is bad. The blower motor resistor is held in place with 2 screws and attached into the heater housing under the right side of the dashboard. You can identify the resistor by the big wires that are connected to the connector. If this heating/cooling system is the auto temp type, the part is a bit high on the price.

Posted on Feb 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater core


You need review details in the Service Section-24-Heating-Air-Conditioning and Section-24a-Heating-Air-Conditioning

Hope helped with this (remember rated this help). Good luck.

Nov 12, 2009 | Jeep Cars & Trucks

1 Answer

Air/fan/heat only works on high in 2005 Jeep Grand Cherokee, or it will start again if I open and slam shut my glove compartment.


Check the blower motor speed dropping resistor pack and it's connections. It is located in the ducting airflow of the blower motor.

Jul 17, 2009 | 2005 Jeep Grand Cherokee

2 Answers

2000 jeep grand cherokee heated seat drivers side low setting light is coming on but high setting no light


hi this could be down to bad conetion on the wireing , check all conections , clean them down , if that doesnt work then its in the electris somewere . you need to trace it ,

Jun 22, 2009 | 2001 Jeep Grand Cherokee

2 Answers

Heat/AC Blower fan speed only works on High


hello, this sounds like a bad blower motor resistor!! its cheap and easy to change..if you need more info on locations let me know,, good luck.....marty

May 27, 2009 | 2005 Jeep Grand Cherokee

1 Answer

Replace a heatercore in a 1997 jeep grand cherokee


REMOVAL
  1. Remove the heater-A/C unit from the vehicle. "Housing Assembly HVAC : Service and Repair" See: Heating and Air Conditioning\Housing Assembly HVAC\Service and Repair
  2. Remove the heater core retaining screws.
  3. Pull the heater core straight out of the housing.
INSTALLATION
  1. Install the heater core into the housing.
  2. Position the clips over the heater core tubes. Install and tighten the screws.
  3. Install the heater-A/C unit into the vehicle. Under "Housing Assembly HVAC : Service and Repair" See: Heating and Air Conditioning\Housing Assembly HVAC\Service and Repair

Jan 14, 2009 | 1997 Jeep Grand Cherokee

3 Answers

Heat/AC Blower fan speed only works on High


Alot of people have the same problem with the fan switch and blown bulbs. There really is no fix for this. Jeep really screwed up when designing the heater control assembly. The cheapest solution is to buy another unit off Ebay. Can always go to the dealer but be ready to PAY for there mistakes.

Jan 14, 2009 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

460 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...