Question about 1999 Ford Taurus

1 Answer

99 taurus no crank after engine swap, ran fine at first no codes then died. no crank no fuel

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Check starter first to make sure it is not jammed into the flywheel also make sure the battery is fully charged and check the coil pack to make sure you have spark and on the fuel make sure the reset button is not sticking and check the fuel pump relay and check all the vacuum lines and the drive belt

Posted on Feb 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0440 engine stopped


That code is an emissions cannister leak and is not related to the engine failure. IT is most likely the crank shaft sensor that is bad.

Apr 08, 2014 | 1999 Nissan Maxima

1 Answer

99 f250 v10 auto 4x4-cat converter imploded,


The fuel pressure sounds too low. Is it multi-port injection? Check the fuel pressure against your specs for the car and engine. MPFI systems usually require 40-50 psi.

Apr 16, 2013 | 1999 Ford F350 Regular Cab

2 Answers

2002 ford tarus cranks but wont start. 32000 miles. I did not drive much during the last 6 months. I started it and it ran fine drove to a neighbors house when i tried to start it cranked but would not...


First, verify that there is gas in the vehicle. Next, listen for the pump to energize when you turn the ignition switch to the on position. If you dont hear anything, check the fuel pump relay. Swap it with another one next to it, they are often the same part. If it still doesn't energize, its most likely the pump thats failed. If you hear the pump energize, then the pump pressure needs to be checked. A fuel gauge needs to be connected under the hood on the fuel rail to read system pressure. Verify that its at factory specs. If not, replace the pump.

Apr 21, 2010 | 1999 Ford Taurus

1 Answer

Have a 1997 Ford Taurus GL. 3.0 Liter. 230,000miles. It has been a very reliable vehicle over the years until now. Two weeks ago it began to stall while driving. I made it home and parked in the garage. I...


If you connected a jumper wire to pin 5 and 11 and the fuel pump runs, have you replaced the fuel pump relay in the process? Let me know how it goes.

Feb 16, 2010 | 1997 Ford Taurus

1 Answer

99 chevy venture. battery is fine but it won't start.


it sounds like the fuel pump or fuel filter

Nov 06, 2009 | 1999 Chevrolet Venture

1 Answer

Cranks but wont start


is the engine light on, check for codes.
i would then test for fuel pressure at the rail.
replace fuel filter,
check for spark at plug.
dirty air filter.
i could go on...

Feb 22, 2009 | 1985 Ford F150

1 Answer

Wont run after engine swap


hello first thing check firewall ground to engine pass side if connected and good test ignition module if okay possible open signal on the spout connector check one other thing is the timing bypass chip near the distributor small plastic like a fuse size style usauly gray pull it out try to start with out it bypasses computors timing setting for manual adjustments goodluck

Sep 06, 2008 | 1998 Ford Taurus

Not finding what you are looking for?
1999 Ford Taurus Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...