Question about 2006 Chevrolet Monte Carlo
The key is inserted but will not turn to start the car. Tires are not locked and car is in park.
Be sure its all the way in park or try neutral.Its possible that security system does not recognize the key. Is security light flashing or on steady? Shut all doors and windows,trunk,hood, turn off all accessory's,roll down drivers window, turn key off and remove for at least 1 minute, insert key into ignition, try to start leaving key to run position for 20 minutes, turn key to off,wait 15 seconds, try to start again leaving key to run, wait 20 minutes, turn key off,wait 15 seconds, try to start, This should relearn key code. It may relearn after 1 learn cycle and start if system is ok. Hope this helps and that the weather is dry and warm for this procedure!.. i think this may solve ur problem..
thank u rate me!!!
Posted on Feb 10, 2009
I have a 2006 chevy lt monte carlo and i had an issue where i could start the car but but the gear would get stuck and i had to push really hard to put my car in drive reverse etc. and the key did not want to come out of the ignition. Turns out i had spilled some kinda of sugar drink in the middle part and it leaked down to the bottom of the gears and it just needed to be cleaned really good with wd40, and water. just thought i'd share this in case anybody else ever has the same problem
Posted on Aug 11, 2010
Is the battery dead or disconnected? I've had that problem in another Chevy. With battery disconnected it would not return to the off position and allow me to remove the key.
Posted on Jul 08, 2009
Tips for a great answer:
Dec 16, 2015 | 2006 Chevrolet Monte Carlo
Aug 12, 2012 | Cars & Trucks
Feb 23, 2012 | 2003 Chevrolet Monte Carlo
Jul 08, 2009 | 2007 Chevrolet Monte Carlo
Dec 29, 2008 | Chevrolet Monte Carlo Cars & Trucks
1,241 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: