Question about 1999 Chevrolet S-10 Pickup

1 Answer

99 S-10 - Horn doesn't work

So I checked the fuse for the horn. It's still good.

But my horn doesn't work and I don't know where to begin to fix it. Sometimes, I can beat down on the horn pad (hoping the air bag doesn't pop out) and get a small toot (which then kind of freaks me out because I'm not expecting it to work.)

In any case, is it difficult to fix?

Posted by on

  • daffy41 May 05, 2009

    s-10 2000 chev truck horn honks with key off but when you start truck and try horn it dont work.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 239 Answers

Bad ground contact wire

Posted on Feb 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I fix the horn on my 1964 Ford Thunderbird


check for 12 vots of power at the horn itself when pressing the horn button. If there is a reading then replace the horn unit. If there is no reading at the unit I would suspect no contact in the horn button/control itself.

Apr 12, 2015 | Ford Thunderbird Cars & Trucks

1 Answer

My question on my 94 toyota pickup 2wd; how can I check to see if the horn contacts are making contact? since the horn contacts are located under the steering wheel, and the air bag is also located there,...


disconnect the negative batery terminal be fore you mess with the horn. the cover should come off easily and you will the wire for the horn on my car the wire is green

Sep 21, 2011 | Toyota Pickup Cars & Trucks

1 Answer

I have a '93 jeep cherokee and my horn doesn't work. I've checked the fuse and it's fine but now i don't know where to locate the horn itself to check for disconnections or to replace...


LOOK UNDER THE LOWER AIR DEFLECTOR FROM BELOW THE RADIATOR. IF YOU HOT WIRE CAR HORN AND IT WORKS.YOU HAVE TO REPLACE THE WHOLE AIRBAG IN STEERING WITH HORN CONTROL BUTTONS.YOU NEED TO DISABLE AIRBAG IN STEERING WHEEL WHEN REPLACING AIRBAG AND HORN CONTROL BUTTON PAD.JUST TURN OFF RADIO FIRST, THEN DISCONNECT REMOVE THE NEGATIVE BATTERY CABLE.WAIT 20 MINUTES BEFORE WORKING ON AIRBAG AND HORN PAD IN THE STEERING WHEEL.

Aug 12, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

Horn does not work, horn buttons are good, horn contact in steering cololm is good, battery level is good, can't find a fuse in fuse box for horn.


if you take a test light and test all the fuses in the fuse box and if they are good then when pushing on the horn button you can usually hear the horn relay working(click).if it does then you need to check the horn itself.take a wire and run it from the battery positive cable and connect it to were the horn wire connects to the horn,it should blow(make sure of a good connection),if it does then it could be a dirty connection at the horn.if it doesn`t blow then the horn needs replacing.you can also use the test light and test for power at the horn wire at the horn itself to see if the horn is being feed power from the horn button to the horn.

Jul 25, 2011 | Pontiac Firebird Cars & Trucks

3 Answers

My horn on my 1992 mazda B2600 does not work


If you have a test light, unplug the single wire that's plugged into the horn. Connect your test light clip to a good ground such as the engine block or even the battery. Then insert the point of the test light into the terminal of the wire that you unhooked from the horn.Have someone push the horn button and if the test light lights, you do have power to the horn. If it doesn't light, you might check the horn relay. Sorry, I can't tell you where it is in your Mazda though. If the test light did light up when the horn button was pushed, then I would suspect that it isn't grounded properly, or, the horn is defective. Try unbolting the horn and sanding off the rust that formed between the horn and where it mounts. Typically, horns are mounted to the vehicle's frame.

Jul 12, 2011 | 1992 Mazda B-Series

1 Answer

The fuse have been change in the 2006 toyota avalon and the horn still don't work hoe do fix it


Check your horn relay and the wiring going to it. If they're in good order, the horn may have shorted out (hence the blown fuse) and need replacement.

Jun 23, 2011 | 2007 Toyota Avalon

4 Answers

2000 grand caravan. The horn doesn't work. I changed the relay& the fuse. It still doesn't work.


If you ahve checked and replaced these things then you would need to check the collar switch. this is on the steering column, behind the steering wheel.

Jun 12, 2011 | 2000 Dodge Caravan

1 Answer

2000 Lincoln LS HOrn does not work and I already checked the fuses asd they appear to be good. Can you provide any other trouble shoot solutions?


easy check first ,, you need help,, disconnect the 2 wires at the horn itself, Located by the front gill under the hood,, use a multimeter to check for power,, have someone try and honk the horn to see if the horn itself is receiving power, if it is,, the horn went bad, if not,, the contacts in the horn contacts are bad, which doesn't happen often but it does happen, or ( and I don't know on your model, ) you may have a horn relay thats not working, I'll check more to see if I can locate that answer

Jun 06, 2011 | 2000 Lincoln LS

1 Answer

My cruise control doesn't work??...any


jnjkingbird, It sounds like this problem is the clock spring as I don't believe that the horn and the cruise control would share a fuse. However, they do share a circuit in the clock-spring. You can check for power at each unit (horn and the cruise control) which would confirm this. Check each fuse as well. Good luck with this.

May 29, 2011 | 2002 Lincoln LS

1 Answer

Where is my horn relay located in my 92 olds cutlas cruiser ?


have you checked the fuse for the horn you don`t say what you have done to this point,if the fuse is good and you hear a click when you push on the horn button, then the horn relay is good as that is what is clicking,if not you will have to check the horn itself as some relays won`t work if the horn not itself is not working,by running a jumper wire from the battery positive to the terminal on the horn, it should work if not then the horn is the problem.the relay is on the fuse panel under the dash.I think it is a square sided relay

Mar 10, 2011 | 1992 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
1999 Chevrolet S-10 Pickup Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...