Question about 2001 Mitsubishi Mirage

Open Question

TPS Sensor How to replace TPS in 2000 Mitsubishi merage

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
joe russell
  • 84 Answers

SOURCE: how to replace Isuzu Rodeo 2000 TPS Sensor? can i

TPMS sensor? If so the TPMS sensor is in each wheel and is part of the valve stem. The tire must be broken down and seperated from the rim you will need a garage with a tire changer for this. The new sensor just simply screws in place and is torqued down as stated in the specs and recoded for your vehicle. Again a special tool is needed for this. BEst bet is to take it to a qualified garage as it will only take them about 20 mins to do this for you plus the cost of the sensor.

Best of luck!

Posted on Oct 09, 2010

Ad
little_shaws
  • 493 Answers

SOURCE: Where is the camshaft sensor located 2000 Mitsubishi Galant

Probably behind the camshaft sproket. Do you see any wireing going into the timeing cover? how hard is it to remove the top timeing cover & have a look should only be a few bolts

Posted on Jun 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace a throttle position sensor on a 2000 ford contour


Hey DonAld, these are not hard to replace..( I do not know which engine you have..it makes a difference!! ).. take a PICTURE of where the current TPS os positioned and located... the radial (adjustment) location IS critical!!..
here is a link to Autozone, ...O'Reilly's, and Advance Auto should have one too..

Ford Contour Throttle Position Sensor TPS

https://www.oreillyauto.com/shop/ignition---tune-up-16776/engine-sensors-17084/throttle-position-sensor-12043/2000/ford/contour?q=tps

Advance Auto Parts Down for Maintenance

Feb 03, 2017 | 2000 Ford Contour

2 Answers

1993 Mitsubishi 3000gt when mass air flow sensor is plugged in car wont rev past 2500 rpm car was bought with it unplugged. Replaced the mass air flow sensor an still does it. When its unplugged it runs...


The computer only knows the voltage across what it thinks is the MAS. A bad wiring connector and a bad MAS is all the same to the computer. I would change the harness to the MAS before I spent any time or money on any other problem solving.

Mar 19, 2015 | Mitsubishi 3000GT Cars & Trucks

2 Answers

2004 jeep grand cherokee laredo, po162, po123


162 is the O2 sensor and 123 is Throttle/Pedal Position Sensor/Switch "A" Circuit High

Jun 18, 2017 | 2000 Jeep Cherokee

1 Answer

Jerks immediately after starting the engine like its not geating enough fuel i thought it might be the pump in the engine


could be the tps of maf sensor,check if ok check the fuel filter and pump.











TIM.................

Oct 22, 2010 | 2000 Mitsubishi Galant

1 Answer

How to adjust the TPS (throttle positioning sensor) on a 1998 Mitsubishi Montero?


just change the TPS sensor for a new one. It's an a electronic part and can't be ajust it

Oct 11, 2010 | 1999 Mitsubishi Montero

3 Answers

Car starts but will not remain on ...already replaces sparkplugs and fuel pump.


replace the faulty fuel pump relay next to get you going back to normal

Jun 16, 2010 | 2000 Nissan Maxima

1 Answer

When you step on the pettle it misses and wont go. But when you get above 2000 rpms it goes .


Throttle positioning sensor TPS is the most likely problem pretty easy to change

Mar 08, 2010 | 2002 Mitsubishi Eclipse

1 Answer

How do i check the throttle positioning sensor on an 04 Mitsubishi Endeavor to see if it is bad.Service engine light is on. diagnostic tool wont clear the tps high voltage code. I need to know the process...


YOU NEED A DIAGNOSTIC SCANNER THAT WILL SHOW YOU TPS SENSOR OPERATION.WITH THROTTLE CLOSE TPS SENSOR VOLTAGE OUT PUT 0 AS YOU MOVE THROTTLE OPEN THE TPS SENSOR VOLTAGE SHOULD INCREASE TO 5.0 VOLTS THATS WIDE OPEN THROTTLE.

Mar 08, 2010 | 2004 Mitsubishi Endeavor

1 Answer

My 2001 galant hesitates on acceleration. changes plugs oil air filter etc.. any thoughts?


a faulty tps sensor will cause hesitation on acceleration.also a loose or broken place in air duct to throttle body will cause hesitation.also clogged fuel injectors and fuel filter.to save money have car scanned.if you have a faulty tps.the scanner will tell you.

Nov 29, 2009 | 2000 Mitsubishi Galant

1 Answer

Is it possible to adjust a throttle position sensor on a 2000 montero sport?


when your vehical throws a code and you replace the defective part, you must clear the code or the ecm will still recognize it as an active code.

Aug 27, 2008 | 2000 Mitsubishi Montero Sport

Not finding what you are looking for?
2001 Mitsubishi Mirage Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...