Question about 2000 Pontiac Grand Am GT

1 Answer

The heat/AC fan will not go on.

With the dial turned all the way up (1-5 speeds,) the fan will not blow. At first a fuse was blown I changed it and it worked for a few days. After it stopped working I checked the fuse again. But the fuse was not blown. I'm wondering if maybe it could be a resistor, but don't know to much about them. Just wondering if you could give me any ideas on what to check and how!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 104 Answers

When you put the fan on full speed it normally bypasses the resistor. This sounds like a bad blower motor

Good Luck

Posted on Feb 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fan speed wont change speeds on heat or cold cycles


Sounds like the Blower Motor Resistor. The range from 10 to 75 dollars depending on what kind of vehicle. Pretty easy to change.
Blower Motor Resistor Repair Heater Fan Speed Control Chevy Blazer GMC...

Nov 09, 2014 | Cars & Trucks

1 Answer

No ac nd my fan stop working completely


Fuses blow because of higher than normal amperage in the circuit. Not sure what circuit the blown fuse is for but if it is for the fan the fan may be shorted therefore blowing the fuse. If you put fuse in while the ac was still on try shutting off the ac then putting the fuse in. See if it blows then if it doesn't then turn the ac on and if it blows you have at the very least isolated the system at fault.

Jun 16, 2012 | 2001 Chevrolet Impala

2 Answers

2002 ford focus fan knob not working at all 1 2 3 or 4 to turn heat on, although you can feel minimal heat coming from the vents.


Probably a blown fuse? Does the AC light come on when it's turned to MAX setting and the fan is on 1 thru 4 speed?It should.
Check all fuses. don-ohio

Sep 27, 2011 | 2000 Ford Focus

1 Answer

Fan blows on all ac or heat but not 1&5 is this a fuse issue


not on speed 1 or speed 5 would indicate the fan resistor is going bad this is located over near the fan on the right side lower of dash

Jan 24, 2011 | GMC Envoy Cars & Trucks

1 Answer

No air being blown when ac or heater is turned on


Relay, switch, fuse or the motor is bad. Check fuse first, then relay, then switch. If all that fails, try the blower motor

Mar 10, 2010 | 1998 Oldsmobile Aurora

3 Answers

Why wont my heater or ac fan not blow in my car?


Check fuse panel for blown fuse first.

Dec 21, 2009 | 1995 Mercury Tracer

1 Answer

01 grand prix gt blower issues


WEll, the next step is to find where the short is. Disconnect the fan wiring, and replace the fuse again, if it blows, the fault is between the fuse and the fan, but I expect fuse will not blow.

Most likely a fan problem, if the above test does not blow fuse, apply auxillary power to the fan and see if it goes, I expect probably not, but will spark.... if this happens, you would be looking at blower motor replacement.

Sep 21, 2009 | Pontiac Grand Prix Cars & Trucks

Not finding what you are looking for?
2000 Pontiac Grand Am GT Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...