SOURCE: 1976 ford f100 pickup 2wd
The brake bias valve can cause your symptom.Are the outer part of the brake calipers able to slide in and out freely .Jack it up take a wheel off and get someone to push on the brake pedal while you check for correct movement.Lube the slides so it is easier for calipers to return.a chunck of 4x2 wood is useful if you find them too hard to move by hand
SOURCE: how to adjust emergency brake on 1999 ford ranger?
First pull the plug in the braka adjusting tool and make sure you still have enought shoe left to adjust then follow the cable from the rear brakes to the Y that connets the to brake cables then get a wire brush and brush off the threded end of the Y spray with WD 40 and then unlock the locking nut using two wrenches to hold one nut while removing the other then adjust the single end of the Y nut towards the joining part of the Y adjust it till cable is fairly snug jack up the rig so the wheels are off the ground and make sure the wheels still turn freely. are you sure that the auto ajusters are working? if you see the brake lining is less than 1/16 of an inch the thickness of a dime then replace the brake shoes first. If you need more information let me know and if you adjust the cable and need to replace the shoes later you will have to back off the nut to get the shoes on. thanks for using Fixya and if this was helpful please rate.
SOURCE: how to install replacement door handles for 98 ford ranger pickup
remove interior door panel(need special tool to pop plastic clips holding panel to door)with panel off remove plastic film,with window up you should be able to see two 10m nuts-bolts to remove-also have to pop lever off that goes down to door latch
SOURCE: CHANGED EMERGENCY BRAKE CABLE ON 1998 FORD RANGER
change brake switch. my son just changed my brakes and the lights for both regular and emergency brakes stayed on, we changed the switch and now just the emergency brake needs adjusting so that light will go out too <!-- from fixya rte -->
SOURCE: 1990 Ford Ranger 4.0L V6 2WD Brake line to the
Chilton won't offer a diagram because there are many line length combinations which can be used to repair this problem.
Often, technicians reroute the lines around the axle nearby the old line and secure it using plastic cable ties that can be bought at your local dollar store or Walmart.
There is a great deal of flexibility in putting a new line in, as long as it doesn't interfere with other moving parts of the suspension.
201 views
Usually answered in minutes!
×