Question about 2003 Jaguar X-Type

Open Question

X type central locking fault

Hi guys as i drive of my doors lock but then i stop take ign key out doors are still locked i have to use the remote to get out
any idear s
cheers rob lee

Posted by on

5 Suggested Answers

  • 958 Answers

SOURCE: AIR CONDITIONING AND CENTRAL LOCKING

other than gas, it could be a lot of things.

could be an electrical problem, fuse blown, switch not working, fan not working.

could be mechanical problem, compressor stuck, expansion valve won't open, dryer clogged.

regarding the door lock, open the door panel and check the vacuum valve in the door, could be the problem. check also the line going to the door, it may have a leak. check the linkage, it could be bent or would not work properly.

tnx 4 using fixya,

drcool

Posted on Oct 04, 2008

  • 65 Answers

SOURCE: Have an s type rear door doesnt lock manual or

common failure with the door locking solenoid, its the whole latch, quite pricey im afraid.Good luck Davelee

Posted on Mar 23, 2009

raygin
  • 322 Answers

SOURCE: Jag S-Type -intermitent fault where the remote fob does not work

This does not sound like a fob fault - but a locking control module fault , either in the hardware or software of the unit. Get it checked at a Jaguar dealers. When unlocking using the key - as soon as the door is opened you should hear a chime sounding inside the car - this is a timer counting down to sounding the alarm. If you put your key in the ignition as soon as you open the door the alarm should not go off and the chime should stop. If it does not this again points to a fault in the locking controller.
hope this helps - good luck.

Posted on Jul 08, 2009

  • 1 Answer

SOURCE: my jaguar x-type 04, remote lock does not work,

Hi,

I have a similar problem in my x type. Although if I press unlock button on the key first and then use the metalic key to unlock it dissables the alarm.

Also according to the manual if you unlock by the metalic key the car starts a beeping sound its I think 15-20 second timer within which you should put the key and start the ignition (don't need to start the engin) this will dissarm the alarm if not the alarm will go off in 15-20 second.

Hope this information is of any use, am trying to get hold of Jaguar dealers to fix this issue. If you come accross any solution please do let me know too

Posted on Aug 03, 2009

SOURCE: key fob wont open doors or boot or lock them

you need to reprogram keys with the module. there could be a problem with the module though , you need to check it out

Posted on Aug 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Central locking 2005 subaru liberty stopped working on 2 doors


1. Replace battery in remote
2. Replace sensor at rhf door lock (it is inside of door)

Apr 30, 2014 | Cars & Trucks

1 Answer

My Proton Gen 2 seem to have a failure with it central locking ,on closing front drivers door it locks it self even with keys in ign , can anyone asist me . Kind Regards


If it locks immediately, the locking motor in the drivers door is doing the locking. Sometimes due to the manual locking knob getting stuck. If it locks 5-10 minutes after the door is closed, your remote control needs to be reprogrammed.

Sep 16, 2013 | Proton Cars & Trucks

1 Answer

Hyundai Accent 1.4L GLS 2000 Central Locking not working


FOR Central locking not working on 2000 Hyundai accent?Click the link below :-----

http://schematicsdiagram.blogspot.in/2012/03/this-is-how-system-operates.html

This will help.

Thanks.

Mar 01, 2012 | 2000 Hyundai Accent

1 Answer

Security system stops jeep from starting


With the door open engage the locks, then shut the locked door. After door is shut use the KEY note: (NOT THE REMOTE) after you've unlocked the door place key in ign and start the Jeep.

Dec 05, 2011 | 1995 Jeep Grand Cherokee

1 Answer

I have a 57 plate 3 series,the doors will nit unlock but will lock with the remote,also the passenger door and rear doors have deadlocked,can you help?


Hi , this sounds like the fuse has blown for the central locking due to a hi amp draw from a fault lock , depending on the country that you are in you will need to find the fuse for the central locking , for european cars the fuse will be #57 or #72 it will be a 15amp fuse that will nead to be changed to a yellow 20 amp fuse , once the blown fuse is replaced , insert the romote key in its slot and turn the ignition on , then remove the key , open and close the drivers door and the central locking should then work , if this fault re-occures then 1 or more door lock will nead to be replaced, hope this is of some help , regards mark.

Feb 04, 2011 | 2006 BMW 3 Series

2 Answers

I have BMW 330ci, the central locking does not work. Bmw fixed it in a matter of seconds last time it happened but it is expensive. Can i reset the key fob myself ?


put the key in the ign cyl and turn car on and off, remove key and hold unlock while pressing the lock button 3x,the locks will lock and then unlock if you have a second key do the same thing immediatly following except do not cycle key in ign just press the buttons int he same sequence

Dec 21, 2009 | 2001 BMW 330

3 Answers

Yaris 2003 remote control lock problem


You need to reprogram the remote. Please se this website:
http://toyotaownersclub.com/forums/index.php?showtopic=85266

Oct 08, 2009 | 1998 Toyota Corolla

1 Answer

The battery in my key fob for my 2004 Mitsubishi Diamante went flat. How do I reset it now that I have replaced the battery?


1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

Aug 20, 2009 | Mitsubishi Diamante Cars & Trucks

1 Answer

98 deville can't start key disabled


1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

Aug 14, 2009 | 1998 Cadillac DeVille

1 Answer

Remote key fob won'tprogram


1-insert and remove key from ignition two times

2-close and open driver door two times

3-insert and remove key once from ign.

4-close and open drvr door twice

5-insert key into ign.,then close driver door

6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.

7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.

8-press lock/unlock together and hold for a second

9-release,and press lock on remote,the door locks will cycle confirming program.continue to do other remotes you have,steps 8 and 9.if only one in possession,you are done. To end mode open door or insert key into ignition.

You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works

Aug 13, 2009 | 1999 Ford Escort

Not finding what you are looking for?
2003 Jaguar X-Type Logo

Related Topics:

825 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

447 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...