Question about 2000 Mazda Millenia

1 Answer

2000 mazda millenia

2000 mazda wont start I put new fuel pump. filter & plugs

Posted by on

  • Anonymous Feb 22, 2009

    i have the same problem did that work for you

  • Alvaro Domingues
    Alvaro Domingues May 11, 2010

    Do you have spark?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Did you check the starter ? the Maf sensor can cause the problem

Posted on Aug 20, 2009

6 Suggested Answers

  • 21 Answers

SOURCE: i want to know how

Fuel filter is located in the trunk.

1. Relieve fuel pressure
First start up the car in PARK. Open up the hood and pull the Fuel Pump Relay. It looks like a big green fuse. Do this as the car runs. Do not worry the car will stale. Crank engine a few times and turn off ignition switch. Put the relay back in. Disconnect negative battery cable.

2. Reach filter.
This is annoying unless you can fit comfortably in the trunk. Pull out the carpet cover and you will see a metal cover screwed down by 3 screws. Remove these and you will see the fuel filter.

3. Replace
Lay down some shop towels underneith the hoses connected at both ends of the filter as fuel will spill out. What I did was place forceps on each hose to minimize spillage. This is also why we releive fuel pressure so it doesn;t spray in your face. Hoses may be stuck onto filter so I took a very small flathead screwdriver and wedge it between the the hose and the filter nozzels so it will free itself from the filter. Becarful as the fuel filter is filled with fuel. Replace filter and follow your steps back.

Posted on Jul 31, 2008

picatudo
  • 239 Answers

SOURCE: 2000 chevrolet express van wont start

yes, new pump inside tank

Posted on Jan 03, 2009

emissionwiz
  • 60792 Answers

SOURCE: Location under hood for fuel pump relay on 2002 Mazda Millenia S

JUST RELEASE THE PRESSURE AT THE FUEL PRESSURE TEST PORT ON THE FUEL SUPPLY RAIL THAT SUPPLIES THE INJECTORS, IT IS A METAL VALVE LIKE A TIRE VALVE, THAT IS THE FACTORY RECOMMENDED METHOD..

Posted on Mar 11, 2009

  • 750 Answers

SOURCE: my hold light is flashing in my 2001 mazda millenia

hold light flashing means you have a transmission fault of some kind, check vehicle speed sensor

Posted on Jul 03, 2009

wracefans24
  • 1985 Answers

SOURCE: How to Replace a Fuel pump on a 2000 Mazda 626

yes it isn't that much if you buy them.they slide inside the coupler and release the line.

Posted on Dec 27, 2009

Testimonial: "Thank you didn't know if there was a tool for this."

  • 4 Answers

SOURCE: 2000 hyundai accent wont start cuz no spark but

itsounds like an immobillzer problem is the yellow key light on the instrument panel lighting up if not thats why there is no spark and i bet u dont hear the fuell pump running either

Posted on Mar 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 mazda millenia seems to be getting fuel but was told not getting enough and car wont start


have a fuel pressure test done. Run fault codes and look for a can purge valve/ solenoid fault.

Apr 26, 2013 | 2000 Mazda Millenia

1 Answer

2.3 mazda millenia s will not start


faulty ignition pack
the ECU detects a fault and runs the engine for 12 cycles and then shuts down
remove the packs on each spark plug and place one at a time on one of the front pack connector with a spark plug inserted into the end and grounded
turn the engine over and you will get a spark ...test each one of the coil packs until you find the one that does not spark ...replace pack
I assume that your model is a 1995 with coil packs with 4 pins ...if they are 3 pins disregard the above

Nov 11, 2012 | 2000 Mazda Millenia

1 Answer

How do I check the fuel pressure on a 2000 model mazda millenia with a 2.3 engine in it


Hi.

You connect a fuel pressure gauge like this to the pressure rail. Pressure in this car must be between 35 and 45 psi. If pressure is too low look for kinked fuel lines and eventually replace the pump. If the pressure drops down more than 10 psi in five minutes or if the pressure is considerably higher than that replace the fuel pressure regulator. Below the parts that may need testing:

ginko_261.gif

1. Fuel tank
2. Shut-off valve
3. Non-return valve
4. Fuel pump
5. Fuel pump (Transfer)
6. Fuel filter (High-pressure)
7. Injector
8. Pressure regulator
9. PRC solenoid valve
10. Fuel pump relay
11. Fuel pump resistor and relay (KJ model)

Aug 04, 2011 | 2000 Mazda Millenia

1 Answer

Wont start after it ran out of gas after I filled it with gas


Cycle the key several times to the run position and then back to the off position to try to bleed the air out it. Let it sit for about 30 seconds between cycles. How much fuel did you put in the tank. I would say that you need to put at least 2 gallons in it. You may need to change your fuel filter. When you ran it our of fuel you clould have picked up crud off the bottom of the tank and plugged the filter. You mave have damaged the fuel pump. Remove your gas cap and have a helper turn the key to the run position not start position. You should hear your pump buzzing. If you don't hear it I would suspect that something is wrong.

Apr 25, 2011 | 2001 Mazda Millenia

1 Answer

Where is the fuel filter on a 2000 Mazda Millenia 2.3 V6


Fuel Pump-Mounted Filter
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable
    • Fuel pump cover plate
    • Fuel lines from the fuel pump
  4. Raise the fuel pump from the tank.
  5. Remove the fuel filter assembly.
To install:
  1. Install or connect the following:
    • Fuel filter to the fuel pump. Lower the pump assembly into position
    • Fuel lines
    • Negative battery cable
  2. Start the vehicle, check for leaks and repair if necessary.
  3. Install the fuel pump cover plate.

Inline Filter
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable

bcd3f99.gif
Exploded view of an in line fuel filter and related components

  • Air intake hose and/or filter housing, if necessary
  • Fuel line clamps, if equipped
  • Fuel lines from the filter and plug the openings
  • Filter clamp bolt/nut by loosening them.
  • Fuel filter from its mounting bracket

  • NOTE Note the direction of the flow arrow on the filter so the replacement filter can be installed in the correct position.


    To install:
    1. Install or connect the following:
      • Fuel filter in its mounting bracket, making sure the flow arrow is pointing in the proper direction
      • Fuel lines to the fuel filter
      • Fuel line clamps, if equipped
      • Air intake hose and/or filter housing, if removed
      • Negative battery cable
    2. Pressurize the fuel system and check all connections for leaks.

    May 24, 2010 | 1998 Mazda Millenia

    1 Answer

    I cannot locate fuel filter on my 1995 mazda millenia


    the filter is in the fuel tank along with the fuel pump.

    Dec 29, 2009 | 2000 Mazda Millenia

    1 Answer

    I cannot locate the fuel filter on a Mazda xedos 9 miller cycle engine - where is the fuel filter on a Mazda Xedos 9 Miller cycle engine


    Mazda fuel filters are usually found underneath the back seat. At least that's where mine was. I have a Millenia. Good thing back seats are easy to remove.

    Oct 13, 2009 | 2000 Mazda Millenia

    1 Answer

    Trying to start my 1996 mazda millenia


    check your fuel filter it may clogged.

    May 29, 2009 | 1996 Mazda Millenia

    2 Answers

    Fuel filter on a 1996 Mazda Millenia


    The fuel filter is accessable from inside the trunk. remove the trunk carpet mat. You will notice a circular panel on the left side which is held to the trunk floor with two screws. remove the screws and panel and you will immediately see the fuel filter. When replacing the fuel filter, note the direction of fuel flow and Do Not Install The New Fuel Filter Backwards!

    Sep 12, 2008 | 2000 Mazda Millenia

    Not finding what you are looking for?
    2000 Mazda Millenia Logo

    Related Topics:

    329 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Mazda Experts

    yadayada
    yadayada

    Level 3 Expert

    60792 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6811 Answers

    Are you a Mazda Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...