While turning the wheel in either direction i hear a clunking noise in the front end
SOURCE: SHAKING AND KNOCKING NOISE
it could be tht the exhaust pipe is loose and therefor makes shaking and kinda banging noise. hope i helped! ;-)
SOURCE: Jeep Liberty Clicking Noise
Check the wheel bearings. Run the car and check where the noise is coming from. the wheel bearings make a gravelly, clicking noise if the bearing is bad. Lift the car and move the wheels up and down , to the sides etc. Listen or if the wheel moves , your bearing may be bad.
SOURCE: 2004 jeep gran cherokee front end clunk
you must replace and lube the front sway bar bushings,chrysler service bulletin calls it a squak, but can sound like a rubbing, a clunk etc the common factor is this is really noticeable the colder it gets outside
SOURCE: The front end of my Jeep Grand Cherokee makes a
Clunking noise can be caused by any item in the steering, suspension or driveline. You are going to have to get under there and start checking things. anything with excessive play, showing rust from a joint boot etc. is suspect. I could write out a list and the one Item I forgot to put on there would be the item that's bad. If you can isolate the problem and need help removing it, I'm here to help!
Good luck
SOURCE: 96 jeep grand cherokee laredo popping/grind noise when turning l
Ifound the same condition in the rear end of my 1993 Jeep Grand Cherokee Laredo with 4.0 HO L-6. I opened up the differential and removed the spider gears and axles to get the components out for inspection. I discovered that of the two
clutch packs that are on either side of the axle housing behind the side/axle
gears, the drivers side clutches had a huge break in the main washer "HUGE"
that is directly behind the side/axle gear. Fluid was not unusually dirty but
does show alot of silver clouding from the loss of metals due to the clutches
slipping and grinding when that crack would allow contact loss. Hope that helps
3,273 views
Usually answered in minutes!
×