Question about 2004 Hyundai Santa Fe

Open Question

CAR RADIO NEEDS CODE

ERROR MESSAGE IS ON CAR RADIO FOR 2003/2004 HYUNDAI SANTE FE IS 1CDE----

Posted by on

6 Suggested Answers

SOURCE: spark plugs and wires on 2003 santa fe

why would you fix a problem that is not there.if it is fine then enjoy it.plugleads only get changed if faulty.

Posted on Jul 17, 2009

SOURCE: Ho to replace serpentine belt. cant find anything

There probably won't be any adjustments. Serpentine Belts have be used for 25 or 26 years to my memory ,and have spring loaded tensioners to keep belt tight. So I quess your new to the car world. You release the tension with a long 1/2" Drive ratchet or tool specific for belt replacement. If you need to buy any tools you don't have, your better off leaving it to the pros

Posted on Oct 01, 2009

RonPark
  • 855 Answers

SOURCE: i need to change the timing belt

If your belts are squealing it is the drive belt/belts that need attention not the timing belt. You need to check your belt tension and condition and replace as needed. If a timing belt ever got to the point that it might squeal the car would not run because it would be too far out of time. Your belts will all be external whereas at timing belt is internal and a major part of the engine.

Posted on Dec 02, 2009

  • 1 Answer

SOURCE: I can't change the time of the clock on the Hyundai 50645P CD player/AM FM clock. There is no information in the Sante Fe manual. Any advice?

Try this, put the key in the ignition and let it be on the first turn right marked "ACC" or you can turn off the stereo and you will notice that only the Digital Clock screen will show. Turn the Volume/Audio/Sel knob and press on the "DISP" button simultaneously for about 4 seconds then release the "DISP" button. The digital clock will start blinking, and then use the Tune/Seek arrows pointing up and down to change the time. If the hour digit is blinking change the hour and after you have changed it press "DISP" then the minute digit will start to blink change it using the arrows, when you are done press "DISP" again or leave the clock for between 4 to 8 seconds the clock will start working normally.


I hope this works for you.


Good luck!


Aquinas

Posted on Oct 11, 2010

  • 1114 Answers

SOURCE: 2003 Hyundai Sante Fe. Error code is P0444 and the

Evaporative emission control valve

Posted on Jan 04, 2011

mikek92580
  • 378 Answers

SOURCE: After disconnecting the battery on my 2004 Hyundai

look in the glove box the owners manul there is 5 or 6 numbers some where if cant find them in the car call the dealer.goodluck

Posted on Mar 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the auxiliary input in 2007 sante fe elite


If you don't see anything on the radio saying "auxiliary output" with a little earphone jack then you aren't Aux ready.

You might be able to go to a stereo shop and have them install an auxiliary output plug. They will pull the factory stereo out and splice/plug in an output wire that you can plug your iPod into.

Mar 28, 2014 | 2007 Hyundai Santa Fe Limited

1 Answer

The check engine light just came on in my 2004 sante fe but its running fine


Yes, it's still running fine, but you have to check the error code and fix it

Mar 26, 2013 | 2007 Hyundai Santa Fe Limited

1 Answer

2007 Sante Fe throttle position assembly error code. Car operating in limp mode. Is this a proprietary type dealer part/repair? Sounds like there is a new


nevr go to a dealer -dont hav smarts like independents--since that part is cheap bring it to advance or zone and replace-they will clear the code

Sep 06, 2012 | 2009 Hyundai Sante Fe

1 Answer

2002 Hyundai Sante Fe 2.7 cd/cassette/am/fm


Internal electronics failure. Whenever this issue rears its ugly head, we replaced the entire unit as no repair facilities are available.

Sep 02, 2011 | 2002 Hyundai Santa Fe

1 Answer

Won't play just says 1CDE on screen


Some cars if you disconnect the battery more then 30 secs you got to put a code in the radio to play it again. They probably have the code written in your Car Manual if not you got to take the radio out and find the serial no# on the back of the radio. Write it down tell the dealer it and they should tell you the code.

Mar 27, 2010 | 2007 Hyundai Accent GS Hatchback

1 Answer

2003 sante fe runs rough


Hope you changed plugs as well
When you had problem with coil,plugs will get damaged,and will malfuntion

Jan 02, 2010 | 2003 Hyundai Santa Fe

2 Answers

I can't change the time of the clock on the Hyundai 50645P CD player/AM FM clock. There is no information in the Sante Fe manual. Any advice?


Try this, put the key in the ignition and let it be on the first turn right marked "ACC" or you can turn off the stereo and you will notice that only the Digital Clock screen will show. Turn the Volume/Audio/Sel knob and press on the "DISP" button simultaneously for about 4 seconds then release the "DISP" button. The digital clock will start blinking, and then use the Tune/Seek arrows pointing up and down to change the time. If the hour digit is blinking change the hour and after you have changed it press "DISP" then the minute digit will start to blink change it using the arrows, when you are done press "DISP" again or leave the clock for between 4 to 8 seconds the clock will start working normally.


I hope this works for you.


Good luck!


Aquinas

Apr 19, 2009 | 2004 Hyundai Santa Fe

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...