Question about 2000 Renault 181

1 Answer

Valve pressure renault laguna

Last time i had valve pressure was broken i changed it but the system on my car is still telling me that the pressure valve is still not working

Posted by on

  • myearwood0 May 11, 2010

    has the system been reset/reprogrammed

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 20 Answers

You must make sure the senser is the correct one.each wheel senser has to be correct.they are not the same.i think they are colour coded.say rear wheel wont work on front etc.sometimes inflate pressure to around 45psi on side that is faulty then let pressure down to correct level resetts the senser.otherwise think its renault dealer to reset computer

Posted on Jun 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im looking for a tyre pressure sensor for my renault laguna 2033 plate but not sure what im looking for or how to fit one thank you


1. The tyre has to be removed to fit the tyre valve/ sensor unit to the wheel. . Tyre dealers will do this for you when you supply the sensor.

2. Any renault dealer parts department can sell you a new sensor.

3. The new sensor has to be programmed to the car's tyre pressure monitoring system (TPMS).

3. Here is a list of information about the Renault Laguna tyre pressure sensors to assist you. The 2nd link below shows a picture of the tyre valve/sensor unit that fits to your wheel.

http://www.petercoopercarrepairs.co.uk/renault_laguna_mkii.htm

Renault Laguna Megane Tyre Pressure Sensor World Car Parts Store

Jan 07, 2016 | Renault Cars & Trucks

1 Answer

Laguna coupe 2009 how do i change pollen filter please


Last one i done not so long ago was behind the glovebox but it was a older car

Nov 04, 2014 | Renault Laguna Cars & Trucks

1 Answer

Why is my renault laguna ii losing power and will not rev above 4000 ?


had similar issue but with laguna 2.0 IDE where there are 2 sensors at the end of the fuel rail left hand side of engine looking into engine bay from front of car, they both look like cylinders about 2 inches high with terminal points for wires on top, replacing the sensors resolved the issue but they were really expensive and only available from renault, i was able to run the car as long as i stayed below 4000 revs if i removed the lead from the top of one of the sensors. be aware if you do change the sensors yourself, do it a while after you have last used the car and engine is cool, as removal of sensor causes the pressurized fuel to come out at speed all over you. hope it helps

May 30, 2014 | 2005 Renault Laguna 1.8

1 Answer

Laguna 2.0 16v 2003 plate not running smooth when low revs


Might be, have a fuel pressure test done on it, that will show if there is a fuel problem, or there is something else causing it.

Aug 25, 2009 | 2000 Renault 181

2 Answers

RENAULT LAGUNA MARK 1 IDLING PROBLEMS AND


I had the same fault on my laguna remove idle air valve and clean with carb cleaner
then lightly oil with light oil like 3in1 DO NOT use WD40 as it goes sticky when the
solvents dry out replace valve and check connections

Worked on my car 2 years ago and still OK

May 03, 2009 | 2000 Renault 181

3 Answers

RESET TYRE PRESSURE SENSOR ON LAGUNA COMPUTER


I had a new sensor fitted recently at a tyre centre, but after driving home one of the rear tyres disappeared off the display! I had them reset the whole system only to find it happened again soon afterwards. Just looked at the fuse panel (right hand side on UK cars, at end of dashboard), no 'reset' switch. However, I did pull out a few fuses to see if that worked. By pure luck, there is a fuse with a strange name (can't remember it now) that is like disconnecting the battery completely (it's a 10A fuse located 3rd down from the top). Plug it back in and hey presto, no more flat tyre warning light, and centre screen shows all 4 tyres correctly. Genius!!

Feb 18, 2009 | 2006 Renault Le Car

1 Answer

Set clock time to 12hr display


work the knobs ,hold it down for 10 secs and it should change

Oct 26, 2008 | 2004 Renault 181

1 Answer

Tyre pressures for renault laguna


32 psi in the front and 30 psi in the back. if the tyre preasure monitoring is acting up even with the preasures ok. take the car to a renault garage to have them re initialised

Jul 26, 2008 | 2001 Renault Sportwagon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

xxxxxx xxx

Level 3 Expert

4706 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...