Question about 1994 Chevrolet Suburban

3 Answers

Shifter cable broke in 1998 chevy suburban

How hard is it to replace a shifter cable in a 1998 chevy suburban checked it and both ends are still attached so it broke somewhere in the middle????

Posted by on

  • 1 more comment 
  • ladylucinda7 Feb 07, 2009

    yes it's an automatic

  • Anonymous Feb 22, 2009

    1998 Chevy C-1500 2wd Shifter cable very stiff.. I understand how to get it all apart from tranny to cab but can't figure out how to squeeze the two plastic keepers for the cable in the bracket on the steering column...I can see it and touch it but can't figure out how to get pliers or what ever on it 'cuz everyhing non movable seems to be in the way...Special tool..?? long angle needle nose...?? HELP...!!! Jim

  • Travis Humphries
    Travis Humphries May 11, 2010

    I am Guessing that it is an Automatic?????? ;)

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,990 Answers

Ok, Disconnect it from the Tranny First. This will make it easier to Fish Through. Connect the New Cable on the Tranny. Follow where the Old one Goes with the New one, Removing the Old one as you go. It will enter the Cab and work it's way up to the Sterring Column. You will Need to remove the Dash Panel to Access the Cable on the Shifter, It just Pulls Loose. You are at the Hardest Part of this at this Point. Let me know if you cannot access the Shifter From this Point. Please Rate My Response! Thanks!

Posted on Feb 07, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 1996 chevy suburban will not shift back into park. have to start vehicle in nuetral. the truck drives like normal. please help!

Posted on Mar 08, 2010

  • daddyof03 Jan 19, 2011

    I have the problem of my truck not going into park. After looking underneath, I realized the plastic casing around the shifting cable may be cracked where it connects to the metal bracket. I wonder if I still have to replace the whole cable, or can I just replace the casing. For mookonski, I could only start it in neutral also, until I found this problem. If I get under the truck and flip the gear forward into park (seems easy to flip, just like a switch with the cable loose) everything runs fine until I stop again, then have to go down under to switch it back to park again, so it is just sitting now till I can get it fixed.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,902 Answers

Shifter cables are easy to replace you just need to make sure that you are doing it correctly so do one end at a time. It sounds to me like it got really tight and snapped

Posted on Feb 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 04 Chevy cavalier. It was driving just fine but last night I went to leave and the gear shift wouldn't go in gear.. It. Just slides back and fourth.


Sounds like the cable broke. Where shifter is, The bezel around the shifter pops off. You can get it high enough to see if it broke the shifter cable mount or not. If it did, you'll have to replace the shifter.

Jul 10, 2016 | Cars & Trucks

1 Answer

1998 pontiac sunfire gt standard transmission diagram having shifter problems trying to find out why


Check that as you move the shifter, that the shifting rods beneath are moving in tune with the shifter's position.
If not, then your mechanism is faulty.
It is almost certain that the issue lies with the external shifting mechanism.
The issue may be just beneath the shifter lever, within the rubber or leather bag shroud. You might have to pull out the centre console to have a closer inspection.

Nov 14, 2012 | 1998 Pontiac Sunfire

3 Answers

2003 trailblazer shift cable broke loose, now tranny is in nuetral but shifter is stuck in park position, thus i now am unable place end of shift cable back on because it dosent line up! please help!


Ok, here is what you do, slide under vehicle, locate shift lever on side of transmission rotate counter-clockwise two clicks, pop shifter on, hop back inside turn key on depress brake pedal and check shifter, if it falls off again replace cable assembly they do not sell individual bushings, and get cable from dealer.

May 13, 2011 | 2003 Chevrolet TrailBlazer

1 Answer

I have a 2004 GMC Envoy the shifter cable came off and I had to put it in park myself. I noticed at the end of the shifter cable that the round plastic washer at the end of the cable broke. How can I find...


Check out this site for the part to fix the transmission end of the cable. Go to the rear end of the transmission on the driver' side (under the car/truck). Make sure to push the transmisssion lever toward the front of the car/truck (park position), the shifter should also be in park. Get the part, install is easy.

http://www.atfbilletparts.com/shifter-cable-repair-kits-by-veh-gmc-vehicles-c-208_219/92-09-gmc-envoy-shifter-cable-repair-pin-p-569

Oct 27, 2010 | 2004 GMC Envoy

1 Answer

How to replace a shifter cable on a 2002 chevy caviler


never did it in a 2002 chvy first off...go to napa...or what ever your local part store is and buy a manual...easy repair...the manuel gives pictures...you replace one end from under the hood...the other you may have to get under the car...if your skinny no prob..if not ...get some jacks...book will explain all..easyl..repair...

Aug 24, 2009 | 1998 Chevrolet Cavalier

1 Answer

Shifter cable change out


YES IT WILL AND ITS EASY YOU CAN DO IT.

Jan 17, 2009 | 2000 Jeep Grand Cherokee

3 Answers

Plastic pieces on shifter handle


That part is only serviced with the sift arm. Source: 20 years at a Ford Dealer as a Technician.

Oct 13, 2008 | 1999 Ford Expedition

Not finding what you are looking for?
1994 Chevrolet Suburban Logo

2,215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

68970 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...