Question about 2000 Plymouth Voyager

2 Answers

I have a 98 plymouth voyager se 3.3l auto (4 speed) and the speedo bounces cause the vehicle to have a jerking motion. when the speedo stays a 0 the vehicle runs fine but this doesn't last long befoer the speedo bounces. it also bounces when you are not moving the bouncing goes from 0 to 200 and when moving its between 20 and 80 . any help would be appreciated We have the same problem and had the speed sensor replaced three times. That was not the issue. Now when sitting at a stand still the speedo shows strange behavior--it bounces from zero to 120 and back. When driving down the freeway, the speedo pegs, which interrupts the engine, the speedo drops. Sometimes, it cuts off the engine because it thinks it is unsafe.

Posted by on

  • claytcrosby
    claytcrosby Feb 19, 2012

    I have a 93 chevy k2500 and speedo started bouncing and kicking out of overdrive,checked battery,alternater,speed sensor ,etc..finally i found that the ground strap from frame to body was broke.I install my owe wire from frame to body and good to go!So happy,thought for sure the dealer was going to have to fix it and charge me a ton.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 38 Answers

I would suggest taking it into a Jiffy Lube or Another Auto-Repair company. They can fix it for sure, and if they don't, you get a refund, and an apology.

Posted on Feb 07, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Plymouth Master
  • 19,396 Answers

The most likely is that you have either a bad speedometer sender, or bad speedometer cable connection.
Also a bad speedometer on instrument panel can cause the same , but is not very common.

Posted on Feb 07, 2009

  • Ginko
    Ginko Feb 07, 2009

    The most likely is that you have either a bad speedometer sender, or bad speedometer cable connection.
    Also a bad speedometer on instrument panel can cause the same , but is not really common.

  • Ginko
    Ginko Feb 07, 2009

    If the speed sensor had already been replaced, then check the sender cable, you will need to access to the instrument panel connectors.
    If the problem is related to vibration, then the most likely is spped sender connection to the speedometer.


×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Im looking for a transmission wiring diagram for a 95 plymouth voyager se with the 3.3l engine


Plymouth Voyager Repair Manual / Service Manual Online ...

? 0:43
https://www.youtube.com/watch?v=2GqbKAZhMcY
Dec 14, 2014 - Uploaded by Tanner Jackson
If you need a Plymouth Voyager repair manual, you're in luck. ...steering, suspension, engine, transmission, air conditioning, heater, or something ... 1994, 1995, 1996, 1997, 1998, 1999, 2000 (90, 91, 92, 93, 94, 95, 96, 97, 98, 99, 00) .... Plymouth VoyagerDodge Caravan 1996 19971998 1999 2000 3.3L ...
images for wiring diagram plymouth voyager

Nov 28, 2015 | Plymouth Cars & Trucks

1 Answer

Where can i find a diagram of the cover of my engine fuse block for my 98 voyager grand se


http://www.ebay.com/sch/i.html?_trksid=p3984.m570.l1313.TR0.TRC0.H0.Xengine+fuse+box+cover+98+gran+voyager+se&_nkw=engine+fuse+box+cover+98+gran+voyager+se&_sacat=0&_from=R40

Jul 13, 2014 | 1998 Plymouth Grand Voyager

1 Answer

Where is relay for the cruise control on a 1999 Plymouth Voyager SE


are you asking is there one or for us to search endlessly for it?
why not post the symptoms and ask for diagnosis.??

i looked for you, at alldata.com and there is NO RELAY
check fuses. first. ,first always.
read the FSM read how to test the system.
on your car (modern) the PCM controls speed.
the PCM uses MPH as inputs and brake pedal switch
and then operates a SINGULAR
speed control module .
called
the vehicle speed control servo (has 3 solenoid valves inside and 4 wires)

the module is dead if the brake switch fails. 100% dead
wires,
1 brakes off.
2 ground.
3: vacuum solenoide
4: vent solenoid.... these are not real pin numbers. its a list.

Jun 20, 2014 | 1999 Plymouth Voyager

1 Answer

Where is the camshaft position sensor located on a 98 plymouth grand voyager and how to fix it?


Guessing it's a 6 cyl, 3.0L, but should be located on transaxle housing above vehicle speed sensor.

Aug 17, 2010 | 1998 Plymouth Grand Voyager

1 Answer

1999 plymouth grand voyager se transmission shifts into 2nd imediatly and stays there, speedometer and odometer not working. overhead console comes on but not working


probably has a bad input or output speed sensor gone bad.they have a known 100% fail rate.check codes first if there is a bunch of them and one is input or output speed sensor then thats whats wrong, replace both they are only 20 bucks each and just screw in

Mar 22, 2010 | 1996 Plymouth Grand Voyager

2 Answers

Where's the crankshaft position sensor located in 98 plymouth voy


Guessing it's a 6 cyl, 3.0L, but should be located on transaxle housing above vehicle speed sensor.c937fe4.jpg

Aug 31, 2009 | 1998 Plymouth Voyager

1 Answer

1996 Plymouth Voyager missing violently, hesitating, dying,


Take it over to a Auto Zone store they advertize that they will read the diagnostic cods for free. with the check engine light on there are codes logged in the cpu. the codes will point you in the direction to go. this will save you lots of time.

May 25, 2009 | 1996 Plymouth Voyager

1 Answer

1995 honda accord speedometer and odometer not working


Sounds like either your speedometer cable, your nylon gear on the side of the tranny where the cable ties in, or the odometer itself is shot. One of those three will set you straight. If you are able, remove the cluster, take the cable off the back, and pull it out of the sheath. You will see if its broken or not from there. If not, slide it back into the sheath, then you have to find out where the sheath meets the tranny, and pull it off of there. Then, you can get someone else to watch the speedo as you turn the cable from the bottom. If it works, great, if not, then its your cluster/odometer/speedo. If it does work, the small gear in the transmission is shot.

Feb 13, 2009 | 1995 Honda Accord

1 Answer

Transmission pump on a 98 plymouth voyager se


You should have a few special tools ready.
Fender to Fender Engine support.
Transmission Jack
A Lift would be real nice
Once the Trany is out it will be easy to remove the pump. It's putting the new one back in that can cause you some real headaches.

Nov 21, 2008 | 1998 Plymouth Voyager

Not finding what you are looking for?
2000 Plymouth Voyager Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...