Question about 1992 Honda Accord

1 Answer

Two Poblems or areas of concern

D4 light is blinking but car runs fine no problems now it has stopped blinking and runs btter than it did when blinking second is i need to know how to reattach the hood release lever where the cable hooks to the hood latch it came loose so now ai have to drive with it not locked as the hood release wont work

Posted by on

  • 1 more comment 
  • installer_ma Feb 06, 2009

    the cable for the hood release has come loose how do you reinstall it. as far as the blinking light what needs to be checked as the car is running fine shifts through all gears and runs great getting about 340 miles per tank 17 gallon tank

  • yadayada
    yadayada May 11, 2010

    well u still have a trans problem and soon it will fail one way or another.

  • yadayada
    yadayada May 11, 2010

    the light blinking is alerting you to a problem in the transmission.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 59 Answers

Your TCU (Transmission Control Unit is bad, it has a burnt diode in it. You can find it behind your Passenger side kick panel and you can puchase it on ebay for about 79.00 with exchange.

Lugnut61

Posted on Feb 10, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 Honda Odyssey automatic. randomly it will have a slight jerk, then check engine light comes on and d4 light blinks while driving on freeway. the speedometer works fine when these lights appear...


First thing to do is have the computer checked for trouble codes. The blinking D4 light means overdrive is not going to function, probably because of the rough running engine.

Feb 14, 2014 | Cars & Trucks

1 Answer

D4 light started blinking, speedometer stopped working and mileage gauge


Vehicle speed sensor. Top of the tranny is a connection. From this, a cable runs to the back of the odometer. Probably need to replace it

Feb 16, 2013 | 1995 Honda Accord

2 Answers

Blinking d4 light with intermittent speedometer


Usually it means the speed sensor in the transmission is failing.
The blinking light means your overdrive may not work.

Dec 11, 2012 | 1995 Honda Accord

1 Answer

D4 light on no matter what gear i'm in. 95 Honda Accord LX 4-cylinder. Already replaced solinoid, speedometer, fan,


The D4 light is coming on to tell you that there is one or more fault codes set in your transmission control module. The only way to retrieve codes on the 1995 models is to read "Flash Codes" output by the D4 light. (See instructions below)

RETRIEVING FLASH CODES USING THE D4 LIGHT
If fault codes are present, the D4 light will "blink" when the ignition is turned to the RUN position and will remain on at all times when the engine is running.
To retrieve the flash codes, turn the ignition switch off.
Install a jumper wire between the service check connector terminals.
The service check connector is a gray, 2-pin connector located on the PCM/TCM cover under the passenger side of the instrument panel. (See picture below)

CAUTION: DO NOT use the 3-pin located next to the service check connector.

Installing the jumper will place the PCM/TCM in diagnostic test mode.
Turn the ignition to the RUN position. Codes will be output by blinking the D4 light.
Note the number of blinks from the D4 light. A short blink indicates a single digit flash code. A long blink equals 10 short blinks. For instance one short blink indicates code 1. One long blink and four short blinks indicates code 14. If there is more than one fault code, they will be output one at a time from the lowest numbered code to the highest numbered code. It is recommended that you read the code or codes several times to make sure that you are reading it correctly.

Once you have retrieved the fault code(s) re-post your question and include the information for what codes you have and someone can then help you locate the cause of the problem.

May 22, 2011 | Honda Accord Cars & Trucks

1 Answer

My D4 light is blinking. I just put in a new transmission and engine, car seems to run fine. But why is my D4 light blinking?


The blinking D4 light indicates a transmission problem. If someone installed the trans and engine for you, bring it back to them to determine what the problem is, as it should be under some type of warranty hopefully. If you did the swap yourself, I would scan for codes (free service at parts stores) to see if any come up. Last, you could try disconnecting the neg. battery cable for about 10 minutes, reconnect, which should reset the computer and the light should go off. If it comes back on, there is some kind of problem still.

Jul 30, 2009 | 1998 Honda Civic

2 Answers

92 honda accord lx D4 flashes


you have a transmission fault the D4 light blinks to tell you that there is a transmission problem when the light is blinking the transmission computer put the transmission into limp home mode so it will not shift normally and you should try not to drive it very far when it gets to this stage you need to have the transmission codes check to pin point the problem

May 29, 2009 | 1992 Honda Accord

2 Answers

ENGINE TUNS OF BUT WONT START


try checking the trans fluid level if its not that check connection on trans control module located under carpet on passenger side floor behind a panel same location as engine control module

Apr 25, 2009 | 1992 Honda Accord

3 Answers

The D4 light started blinking when I was driving the car.


why does the d4 light start to blink and it doesnt stop even if you put it in park?

Dec 04, 2008 | 1992 Acura Legend

1 Answer

Automatic transmision D4 light blink


Check the TCU or TCM located passenger side floor area.
when you take it apart it will have bad soilder connection on the left side. It will need to be replaced.

Sep 08, 2008 | 1995 Honda Accord

Not finding what you are looking for?
1992 Honda Accord Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

63242 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...