The blower is not working on the heating system. I checked the fuse and it appears to be ok.
Before you change the fan speed control module resistor check all the connections are between this and the fan motor are clean. Carefully open and close after cleaning the outside. This unit is difficult to access and it is time consuming unpleasant job. I had the same symptoms and changed it for nothing. It was just dirty at a blower motor connector.
SOURCE: 2002 lincoln town cae blower problem
if you have checked the fuse and they are good and there is power going to the blower replace the blower you should be able to pick one up at a good salvage yard at half the cost.
SOURCE: Lincoln 2000 town car Blower doesn't work at HI-MED-LOW speeds...
it is called blower motor resistor , should be close to blower motor , you will see a plug type connector with two screws , remove the screws and there should be a resistor inside the cover for the motor, swap with new and reassemble
SOURCE: heat wont work 2001 lincoln town car cartia
Hello Callahan5922....this sounds like a stuck blower motor resistor. I assume the blower won't function in the a/c mode either? If you have a digital multimeter you can check this. I believe it's fuse #2....if the digital indicator goes up or down when you increase or decrease the fan speed thats good. Locate the blower motor resistor....you wil find it located on the fire wall behind the right valve cover hiding behind the heater hose, it's about the size of a cigarette pack. With the engine off, and key in on position, turn the A/C on High, and rap a tap tap tap on the resistor. You might be suprised when the blower motor takes off a runnin,
I hope this is the answer you need and i was able to help solve this for you. Good luck...
SOURCE: 2002 Lincoln Town Car AC Blower Motor Relay Location
Relays are normally located under the hood in a protective plastic box. Good Luck Ned
818 views
Usually answered in minutes!
×