GARAGE CONTROL SYSTEM

Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

you need to have automatic ac and heater control checked out at a garage problem could be in the mode switch or electrical problem causing front blend door actuator not working properly.your vechicle has the EATC SYSTEM which is computer control need diagnostie equipment to fix.

The PCM is located in the center of the board in the bottom

I just had the same issue happen with my truck. I have a 2004 F-150 as well and while driving down the road the truck completely shut down on me and seems like the security system on it thinks my truck is stolen. The key fabs will not allow the truck to unlock or lock nor will the key activate anything to start the truck. Does anyone have any advice on how to reset the securilock system on it?

Hi,welcome to fix ya.
there are 2 screws under the ends of the lens heres the location

try putting key in ignition turn to on position
then press lock & unlock several times slowly if door locks cycle up & down after 1st press it lost code and is now resynconised.
now try remote with all doors closed and key out of ignition
if this dont work need to register key(program)back into system which dealer must do with Tech2 if round heart shapped remote

i was told by a jaguar dealer that a phone module c/w bluetooth feature can be added to activate phone system for $1400.00 can

Hi,welcome . Homelink has a website and phone number for programing help contact.
HomeLink at 800-355-3515 or visit their
website at www.homelink.com. they have a very good support system to hep you with problems.

Your traction control is automatic, you shouldn't have to activate at all. If the light is staying on that means you have a problem with the traction control system.

The built-in system in your '98 Jeep is made by a company called "HomeLink", a subsidiary of Johnson Controls Inc. The website, www.homelink.com, has a walk through tutorial that should do the trick. It's a matter of taking and existing hand-held remote control for your opener, pressing and holding its button, and pressing and holding the button you wish to use in the visor at the same time (with the remote positioned very close to the visor). The appropriate flashes on the LED above the row of three buttons will let you know when the HomeLink system is set up. Depending on you opener, you may then need to locate a "learn" button on the overhead garage door opener mechanism, and program the HomeLink system into the opener's memory.