Question about 1992 Chevrolet S-10 Blazer

1 Answer

S10 blazer starting problems

I own a 1992 S10 blazer. in the cold mornings when i start the blazer it takes about 5 minutes to start. in the evening when i get off work it does the same thing.
when it finally starts in the morning and i get to work, i can turn the blazer off and it will start immediately (after it warms up). In the morning and evenings when i go to start the blazer, i can try to start it pause, turn the ignition off and the fuel pump will continue to run for approx 5-7 seconds.
i do hear the fuel pump running before i start the blazer. but its just tough to get started.

any help would be appreciated.

thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,118 Answers

First thing to do is chg. fuel filter, than if that don't help, do a fuel pressure chk. pump might be getting weak. if all that chks. out ok it could be fuel regulator, but most likely its either the filter or pump.

Posted on Feb 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1993 chevy s10 blazer 4.3 has trouble starting in the morning, i live in fl so its not cold, i replaced the pump and plugs still hard to start and acts like its flooded


Your truck requires 60psi or more of fuel pressure to start.
Have you had the pressure checked before and after replacing the pump, and did you replace the fuel filter too ?
Could also be a fuel pressure regulator issue.

Jul 01, 2012 | Cars & Trucks

2 Answers

1993 CHEVROLET S10 BLAZER-WHEN DRIVING IDLE IS AT NORMAL SPEED. BUT, WHEN YOU COME TO STOP, IDLE IS HIGH. WHAT IS MY PROBLEM?


My 93 s10 blazer idles really ruff and i
erratically for the first few minutes until it warms up. It now sound like its going to stall every morning I start it up and black soot comes out the tail pipe onto the pavement but only while its idling rough. After i changed the cap and rotor it idled good for a couple days then started doing it again.Already changed the fuel filter and pcv valve. whats the problem?

Dec 28, 2010 | 1993 Chevrolet S-10 Blazer

1 Answer

I have a 1992 dodge power ram with a 318 in it. When the weather starts getting cooler in the evenings my truck won't start right away. It will turn over for about 5 minutes with the check engine light not...


I would guess a bad spark plug wire. Moist air will provide a path for the spark to jump to ground from a bad plug wire. You could test with a windex bottle filled with water and spray the engine in different spots. Also check for moisture under the distibutor cap.

Sep 07, 2010 | 1992 Dodge Ram 150 Club Cab

1 Answer

1990 chevy s10 blazer 4wd. Xmsn whines.


if this happens only in the morning after you start for the first time its the clutch on the fanblade needs replacing

Dec 02, 2009 | 1990 Chevrolet S 10 4WD

1 Answer

Light knocking at the first start each morning


sounds like a high mileage motor. worn lifters that take a few minutes to pump up. Might add a quart of marvel mystery oil. To improve cold start upper cylinder lubrication.

shack

May 17, 2009 | 2000 Chevrolet Blazer

2 Answers

My 1992 Chevy Blazer S 10 is revving really high when it starts


i have an s10 that would rev up high. i hooked up my scanner and it didn't give me much information, so i started researching. it took a while. i got my manual out and looked up all of the sensors in the fuel system. i even paid some web site $10 for help {wasred my $10} and they were no help. so i researched all of the sensors and found out their symptoms when they malfunctioned. the culprit turned out to be my water temp sensor. here is how it works, when you first start your engine the water is cold, the sensor sends out the information to the brain [warm me up] so your engine idles high to help reach operating temp quicker. when the sensor malfunctions it will send the wrong info to the brain [i'm cold] so the brain revs up the engine in an effort to get warm .i replaced the water temp sensor and the engine is back to normal.

Nov 19, 2008 | 1992 Chevrolet S-10 Blazer

Not finding what you are looking for?
1992 Chevrolet S-10 Blazer Logo

381 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...