Question about 1988 Chevrolet Blazer

1 Answer

Rear seat removal on 1988 full size 2dr chevy blazer

How do I remove the rear seat on a 1988 full size 2dr Chevy blazer

Posted by on

  • rlbechel Feb 09, 2009

    I worked on this on 2-08-09 and found a handle behind the seat. The bolts for the seat were not accessible from the bottom or the top. The handle was stuck so I used a pry bar to move the release latch upward. The entire seat pivoted forward to expose the front mounting bolts which were attached to inner hinges. After removing the front hinge bolts and seat tilt shock, I was able to remove the seat from the vehicle. Thank you for your assistance.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 508 Answers

The rear seat is bolted to the floor either from the inside or the outside. If attached from the undercarriage you will need to locate the rubber plugs that cover the bolt head or the hex nuts to the seat. Just remove these and the seat will come out.

Posted on Feb 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1988 chevy v10 full size blazer has a vibration under power after it warms up i cant find any thing rong or broken

check drive line for wear and loose parts . Check for misfire in a cylinder from injector fault.

Mar 18, 2014 | Cars & Trucks

1 Answer

How do i change out stock speackers in my 2000 chevy blazer?

Let me guess, you have a 2 door, right? On 2 door Blazers, it is very time consuming to get to the rear speakers, you have to remove the bottom kick plate that runs along the bottom of the door, take out the back seat, and then remove the entire plastic side wall from the interior of the truck. I took mine in, they actualy had a special price for installation of rear speakers in blazers.

Jan 27, 2011 | 2000 Chevrolet Blazer

1 Answer

How do I remove or replace the arm rest on my Captains chair? I have a 1995 Chevy G20 van.

how do i remove the broken piece of arm rest from my 1999 full size chevy van . front drivers seat

Jan 24, 2011 | 1995 Chevrolet G20

1 Answer

I need to change out a water pump on my 92 full size blazer.

u might be able to just remove alt and fan and maybe not. Only other things that might needed to removed is a/c compresser, power steering pump and fan shroud (((you dont have to remove shroud but makes it alot easier)))

look at water pump and look to see what all in way of getting to all the bolts

Apr 07, 2010 | 1992 Chevrolet S-10 Blazer

1 Answer

Have a 1998 full size chevy blazer and need to replace the heater core any help

you have to remove the whole dash board, airbags and all, I was quoted for over 2 grand, but got it done for 1300. good luck its a 17 hour job

Nov 21, 2009 | 1998 Chevrolet Blazer

1 Answer

How to remove rear door panel on 2002 chevy blazer

usually two screws one at the armrest and one under the power window console , this console usually pops out to let you at the screw.

Oct 27, 2009 | 2002 Chevrolet Blazer

1 Answer

How to remove a driverside pwr seat from a 1998 chevy s10 blazer

the seat is mounted to either studs or bolted down, there are two in the front and two in the rear, raise the seat up as high as it goes and disconnect the wiring harness, be carefull not to break the connector, move the seat back and remove the front nuts or bolts on floor, there may be a trim cover over them, repeat for rear, move seat foreward to access rear nuts or bolts (varies by year.)

Oct 20, 2009 | 1998 Chevrolet Blazer

1 Answer

Rear speaker replacement on a chevy blazer

You need to remove the rear seat there is no other way of taking them out without removing the rear seat

Aug 15, 2009 | 2000 Chevrolet Blazer

1 Answer

None of the lights will work in my 1988 chevy k 1500

Check fuses, then the switch. I have a 94 Chevy 2dr Fullsize Blazer and the switch went out on mine. It started flickering, then gave out.

Mar 21, 2009 | 1983 Chevrolet Silverado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

401 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides