Question about 2004 Mazda MPV

Open Question

TEMPERATURE GUAGE NOT WORKING

I HAVE A 1996 MAZDA BONGO 2.5 DIESEL. THE TEMPERATURE GAUGE DOES NOT WORK, THE HEATER ONLY BLOWS LUKE WARM AIR AND WHEN I FUEL THE VAN UP, THE FUEL GAUGE MOVES UP TO HALF WAY AND THEN GOES UP AND DOWN REGARDLESS WHATS IN THE TANK. THE FUEL WARNING LIGH DOES NOT COME ON EITHER . IT WOULD BE VERY APPRECIATED IF YOU COULD HELP ME OUT .THANKS SO MUCH.

Posted by on

5 Suggested Answers

AutoDoc
  • 169 Answers

SOURCE: ford escort...fuel guage

What year and was anything been done before the problem started?

Posted on Aug 26, 2008

tommyboinow
  • 324 Answers

SOURCE: 2001 mazda 626 heater/temp gauge?

your head gaskets are bad.... This is a common plroblem wiht those symptoms.

Posted on Nov 26, 2008

  • 1 Answer

SOURCE: my 94 mazda 323s heater doesnt work

Thanks for a reply. Finally it appeared that the problem lays in the alternator, not in the heater. Nevertheless, as I mentioned before heater was not working and that deluded me somehow. After replacing an alternator everything came back to normal. By the way, I replaced both belts (alternator and wedge belt). 

Posted on Dec 17, 2008

  • 11 Answers

SOURCE: 2000 millennia Heater problem

make sure your coolant fluid level is good, than check the valve that controls the amount of coolant that flows to the heat exchanger inside your dashboard, make sure it is wide open. (find it by having someone inside the car move the heat control from hot to cold and back while you are under the hood looking for the valve. Sometimes the cable that goes from the dashboard heat/temp control to the coolant valve comes off.

Posted on Jan 09, 2009

dynocor
  • 5 Answers

SOURCE: mazda bongo 2.5 turbo diesel 1996. over heating

no im a mechanic it sounds like that you have an air lock in the cooling system .i am familiar with ford freda and bongo and the design where the engine is is a bit far from the radiator ,so the problem with air locks magnifies.really the solution is just drain the water and refill it slowly while you are pressing and releasing,just repeat the action on the top radiator hose to get rid of any air trapping within the system,it's as simple as that really.you want it to have just water and no air as this will cause a blockage.

Posted on Nov 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Heater temp on high only bows luke warm air after driving. A/C works just fine.Plenty of cold air from it


heater blows cold air idle chrysler 300 Questions & Answers ...

www.fixya.com > Forum > Tags
Find solutions to your heater blows cold air idle chrysler 300 question. ... blow warmair for a few mins then back to luke warm. i replaced thermostat ... HEAT BLOWSCOLD AIR WHEN IDLING ONLY GETS HOT WHEN START DRIVING ... About 15 minutes after driving the diver side vents start blowing straight cold air but the ...

Heater only works when pressing the gas? - DoItYourself.com ...

www.doityourself.com/...repairs.../459521-heater-only-works-when-pres...
Nov 3, 2011 - When I press the gas, the air from the vents is nice and hot. .... So am Idriving a car with a ton of problems, or could the power steering ... Just anotherquestion, when warmed up does the engine temperature ... When the heater is on and I'm not pressing the gas pedal, luke warm air blows from the vents.

Heater blows cool air when stopped and warm air while ...

https://www.reddit.com/.../heater_blows_cool_air_when_stopped_...

RedditFeb 12, 2014 - Heater blows cool air when stopped and warm air while driving 2008 Kia Spectra (self. ... just fine but appears to blow cool air when I was stopped at a stoplight. ... My temp gauge would also be pegged high when at idle / low RPM. ...thermostat only blocks coolant going to the radiator, and the heater core, ...Missing: 300m ‎luke

Why is My Car AC Blowing Hot Air? - BlueDevil Products

gobdp.com/blog/car-ac-blowing-hot-air/

Jan 27, 2016 | 2000 Chrysler 300M

1 Answer

1996 mazda bongo friendee 2.5 diesel no live supply to the heater plugs can i wire direct to battery


YES, BUT YOU WILL BURN UP THE GLOWPLUGS WHICH ARE PULSED ON AND OFF BY THE GLOWPLUG CONTROLLER.

May 05, 2015 | Mazda Cars & Trucks

2 Answers

I have a 2000 Grand Jeep Cherokee Laredo (6cyl). It was blowing only cold/luke warm air. I replaced the thermostat. Still blowing the same only now the radiator cap is cold but hoses are hot. ...


It is likely you have air in the system. Park on an incline, take the radiator cap off, start the car, let it warm up until the thermostat opens, fill the radiator until it stops going down. See if that doesn't get you some hot air. If not, try the other steps I have in my post at http://www.fixya.com/cars/r6235876-no_heat_fan_blowing_cold_air . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me.

Dec 13, 2010 | 2000 Jeep Grand Cherokee

2 Answers

1999 Honda Accord heater not blowing hot air


Sounds like a thermostat or cooling system issue. Change the fluid and the thermostat. It will do your engine good so it's money well spent.

Dec 31, 2009 | 1999 Honda Accord

3 Answers

Heater


Likely it has more to do with the door that controlls the airflow. Which should be operated by vacum might check and make sure all thevacum lines are plugged in.

Does the gauge in the car show it warms up?

Feb 24, 2009 | 2001 Ford Windstar

4 Answers

2004 Mazda MPV cabin air is just not getting hot enough.


If changing the thermostat didn't work, have the heater control valve checked, it may not be opening all the way to let the coolant circulate thru the heater core fully.

Jan 21, 2009 | 2004 Mazda MPV

7 Answers

Mazda bongo 2.5 turbo diesel 1996. over heating


no im a mechanic it sounds like that you have an air lock in the cooling system .i am familiar with ford freda and bongo and the design where the engine is is a bit far from the radiator ,so the problem with air locks magnifies.really the solution is just drain the water and refill it slowly while you are pressing and releasing,just repeat the action on the top radiator hose to get rid of any air trapping within the system,it's as simple as that really.you want it to have just water and no air as this will cause a blockage.

Jun 28, 2008 | 1996 Mazda MPV

Not finding what you are looking for?
2004 Mazda MPV Logo

Related Topics:

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...