Blowing fuses brack lights/turn sig.fuses keekp blowing out

check fuse relay wiring and switch and if lighter kept blowing fix dont throw in bigger as you see could have burnt truck down

May want to also check your wiring from the fuse panel to the different components that are giving you the problem. I think that you may have a pinched wiring along the way to all the components.

shorted trailer harness, all blink because there is no ground in wiring system. correct the wiring issues for a complete repair

Look in manual that came with car if no manual Google it, check brack bulbs and for bad brack switch at brack paddle

If you keep blowing the brake fuse than you have a short in the system. Unplug the brake switch. Install a new fuse. If it did not blow than the problem is after the brake switch. Next unplug the turn signal switch, then plug the stop light switch back in and press the brake pedal. Did the fuse blow. If not than the wiring is good in between the two switches. With the turn signal switch disconnected use a jumper wire in between the light green wire (power from the brake switch) and the orange with light blue wire (power to the right brake lamp). If the fuse blows than there is a short in the right side brake circuit between the plug in and the rear socket assembly. If the fuse does not blow than jump from the light green wire to the Light green with orange wire (power to the left brake lamp). If the fuse blows than the problem is in the left hand brake wiring circuit.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

The trailer might have a bad ground. My camper does the same thing to my truck. Try directly connecting the trailer ground to the frame of your vehicle. This might solve the problem as it did for me.

Have you checked the brake light switch and the fuse for that circuit ?

Hi, the likely problem is the turn signal switch. The signals and brake lights use different fuses. You can get an owners manual here:
http://www.extendedgmwarranty.com/owners-manual/chevrolet/1996-Chevrolet-Cavalier.pdf

A new switch is about $40, and it isn't too hard to replace. Make sure you get one that has the same controls as yours does. To replace the switch, remove the covers from the steering column, disconnect the switch and unscrew it from the column.

Please let me know if you have questions, and thanks for using FixYa.

Try turning on the emergency flashers(they operate on a different flasher) if all your lights are flashing then all you need is a turn sig. flasher. Easy to find right near or on the fuse block. If none of the emergency lites flash you may have an open cicuit in the turn sig, switch.

Am I correct, the turn signal fuse is blowing when you put the manual shifter in reverse?
Let me know.
Regards