Question about 1989 Ford Mustang

3 Answers

89 ford mustang

My son bought a 89 ford mustang, need help

Posted by on


3 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Check the ground cable its so easy that everyone doesnt check it

Posted on Jun 26, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My mustang has a new battery,the alternator is good,the starter is good and my car still will not start,even with a new battery.all i can think the problem is .an electrical one. what else could it be.

Posted on Feb 22, 2009

  • craig bigham Aug 27, 2011

    Inertia switch,behind rear panel/next to taillight,hatch stricker/latch.Fuel pump relay underneath the drivers seat.


  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 286 Answers


Why not Google..... for a local Mustang Enthusiasts Club ?

Good Luck !

Please give a FixYa Rating Please ....I need to be a Guru !

Posted on Feb 04, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 89 mustang won't run with the maf sensor

you need to replace the mass airflow sensor it is defective for that year should be cheap but most likely will need to be ordered

please leave 4 thumbs if it helps

May 10, 2011 | 1989 Ford Mustang

1 Answer

MY 89 Ford Mustang GT did not pass smog because then Check Engine light DOES NOT light up. Would that be a fuse or bulb?

The light is controlled directly by the computer so if your car runs, it isn't a fuse. It just needs a bulb put in it.

Feb 28, 2011 | 1989 Ford Mustang

1 Answer

How do you remove 89 convertible mustang rear seat

hit it hard (with the side of your hand or palm) at the bottom of the seat on the right and the left to relase the spring retainers, run a putty kniofe under the seat edge to locate the spring retainers

Apr 02, 2010 | 1989 Ford Mustang

1 Answer

89 ford mustang v-6 is the c-clamp going to seat the caliper?

yes it will, just turn in slowly it will set piston bck in,not much force needed if it is hard to seat piston back in caliper you may have a bad hose or caliper, the way to find this out is open bleeder and if its easier to colapse the piston then its a hose if it doesnt make a diffrence then its a bad caliper, but this is only if you have a problem the c clamp will do the job, hope this is helpful.

Feb 19, 2010 | 1989 Ford Mustang

1 Answer

89 mustang runs good under 3500rpm over that it pops and sputters

if you're trying to hold the idle over 3500 , you're going to hit the Rev Limiter, Einstein. Racing cars will lead you to no good , son. If I'm wrong or missunderstanding you please clarify.

Oct 11, 2009 | 1991 Ford Mustang

1 Answer

Mustang 89 4 cyl 2.3 l engine starts on parking dies out on drive

if the nuetral safety was a problem the car would not start at all, sounds like you have a defective engine wiring harness, this is the most common cause of this i have seen while working for Ford.

Aug 27, 2009 | 2000 Ford Contour

1 Answer

Why does my 89 mustang gt blow black on the grass an stals

your gas to air ratio is off. Too much gas not enough air,flooding,check if the gaskets are tight for the fuel area.

Jul 22, 2009 | 1989 Ford Mustang

1 Answer

Blower Motor for 89 Mustang

i've replaced three heater cores on a mustang, the only way to get to them is to remove the dashboard i believe the only way to get to the blower motor is the same way, located behind the glove compartment.

Sep 02, 2008 | 1989 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

278 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5653 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides