Question about 2004 Chrysler Pacifica

2 Answers

Chrysler Pacifica will not start.

2004 Chrysler Pacifica 3.5L V6 Will not crank. Drove and started fine all day yesterday. Went to start last night and nothing. No clicking, no cranking almost as if there was not a battery? Tried jump starting but do not make a difference. All lights, radio, blower and other things work when key is turned but engine does nothing. Any help is greatly appreciated. Just bought used with 66,000 miles. Weather was light flurries low teens for temp if that matters?

Posted by on

  • micahburkhar Feb 07, 2009

    I tried all the above and nothing worked. I'm trying to find a repair manual for the car so i can try and change the starter.

  • khmrizek Feb 26, 2012

    hi, was your car fixed? i`m having the same issue and i`m not sure whats the problem.thx

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I had the same problem, could not figure it out. Looked all over the inter net found a post that said something about the ground wire that had a bad connection. So i followed the found wire and this is what i found. attached photos, plus whati did to fix it.
Chrysler Pacifica will not start. - 9_8_2012_8_50_27_pm.jpg9_8_2012_8_50_37_pm.jpg

Posted on Sep 08, 2012

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 416 Answers

Most probably starter problems. It can be not starter itself some vires coming to it are loose. To locate the starter follow heavy wires coming from battery. This how starter looks like
http://www.autozone.com/N,16400045/shopping/partTypeResultSet.htm
Check the wires coming to it. Also check the fuse, it might be bad starter relay fuse too.
Please kindly let me know it the information was usefull for you or you still need more info
Good Luck

Posted on Feb 04, 2009

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car was woring fine. Went out to drive it. Started up, but dash was totally blacked out. There was a red light by the menu buttons that was on, but not blinking. Car drove dine, but not dash lights, no...


my 04 pacifica did similiar thing. Dash was black and car drove and started fine but found a broken pin in electrical connector behind dash and repaired that and all worked after that

Jul 21, 2011 | 2005 Chrysler Pacifica

2 Answers

Motor started tapping loudly as if there was no oil, oil level was fine, changed oil sound quieted after 20 minutes, sound came back a couple of days later, went away the last couple of days on short...


hi this could be due to your hydraulic tappets, these will start to rattle if the oil has been low at some stage and the oil was to thin this normally sounds worse in the mornings on first start and gets quieter as the day goes on or disappears altogether, what you could do, is use an engine flush, put it in the engine and run it for a period of time, then empty the oil and refill with a thicker grade oil and see how that goes..hope this helps

Feb 24, 2010 | 2006 Chrysler Pacifica

1 Answer

1997 mpv mini van runs great. While traveling i drove from SC to Atl GA....parked and went into motel for evening...the next morning i had very difficult time getting it re started....Like it was not...


I think you should check your battery and alternator.If they both check good you may have a battery draw,something draining the battery over night.Check your doors make sure they are closing like they should.

Jul 28, 2009 | 1997 Mazda MPV

1 Answer

1996 Chrysler Sebring Conv.- Power Drain or Damaged Crank Sensor?


try checking the secondary ground wire that comes off the battery see if its loose or corroded might help

May 29, 2009 | 1996 Chrysler Sebring

1 Answer

Car starts, then doesn't, then does, then doesn't


check the fuel pump relay! It sounds like it is one of your relays. If it was an electrical or sensor problem, the check engine light would be on.

May 22, 2009 | 1998 Mercury Grand Marquis

1 Answer

My 1997 Dodge Avenger's engine won't start


Try cam and/or crank sensor. If crank to cam timing isn't detected properly it'll crank all day but won't start. I had similar problem on my 2.5L V6 Avenger....drove home fine, no engine light, next morning it cranked, but wouldn't start. The crank sensor was faulty.

Jan 11, 2009 | 1997 Dodge Avenger

1 Answer

1993 Nissan Altima will crank but won't start - sometimes - altitude issues?


The system is not affected by altitude in this way, the thing you need to check is fuel pressure, this may be pump related.

Oct 22, 2008 | 1993 Nissan Altima

1 Answer

1995 Chrysler Concorde


the alarm is activating when he locks it and for some reason the key or fob isnt deactivating it..check the disarm switches in the door

Aug 11, 2008 | 1995 Chrysler Concorde

Not finding what you are looking for?
2004 Chrysler Pacifica Logo

1,616 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...