My car doesn't want to start after putting gas in it
SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
SOURCE: 2001 Sebring convertable, 3.3L, Turn the key
you have a crossed wire thats blowing the fuse. Check all wires to the starter also to the fuse box and to the battery
SOURCE: 2005 chrysler sebring..car starts then dies...gas
sorry to ask a question that may sound stupid but, are you using the main ignition key. my car came with 2 keys that seem identical except that the part of the key that you hold when turning is different. one is thick and grey the other is thinner and black. the grey one works to drive the car the black one only starts it but then the car dies as soon as i take it out of park. the black key is just a spare for the doors.. it is lacking the microchip that sends a signal to the engine that it is genuine and should start the engine.
SOURCE: need the crankshaft main bearing torque specs and
Hello tlittle3: My name is Roger and I will help you.See the attached image. Be sure to follow steps as it is very inportant. You will notice that you need to index some of the bolts. That is merely turning the bolt a specified degree. The crankshaft tie bolts are the bolts that are in the side of the block. install horizontal. Shold you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger
Testimonial: "thanks that what i needed"
SOURCE: the fuse of my chrysler 2001 sebring is blowing
yea agree but first listen when u turn the key, if the fuel pump makes some noise it means u have a problem with the starter! if no sound from the pump (sound should comes from the back seats) then its pump!
57 views
Usually answered in minutes!
×