Question about 1988 Toyota Cressida

Open Question

Need to disable car alarm on 86 Cressida

Can anyone direct me to where I can find a wiring diagram so that I can disable my car alarm.

The alarm has disabled my starter and now my car is out of commission..

Can anyone please help direct me?

Thanks!

Posted by on

  • elfofo_jose Apr 25, 2009

    The alarm has disabled my starter and now my car is out of commission..

  • jprice386 Jun 16, 2009

    The only solution to the car alarm disabling issue that I have come up with is to disconnect the negative battery cable for 5 seconds. This happens when you least expect so I suggest that you carry a box-end wrench in the car at all times so that you can quickly loosen the battery cable tightening nut.



    This the best and most economical solution.



    Jeff Price

×

5 Suggested Answers

SOURCE: 86 toyota cressida. how to remove

we used a ratcheting flex-head stubby gearwrench (and contortionist maneuvers) to break free the nut then used fingers to hold the bolt still while using gearwrench to move the nut (may be painful and cause cramps).

Posted on Sep 18, 2008

  • 91 Answers

SOURCE: did the 96 toyota camry come with an alarm if so how do I disable

actually your car has to have keyless entry, it's part of the alarm system that is given you problems. I had a similar issue with my 87 camery, sounds like they still haven't fixed it in 96.. anyway the fix was for me to take the VIN number over to my local dealer dish out about 35 bucks and get the remote control unit for the alarm system. That also gives you keyless entry :).. So for 35 bucks it was well worth the investment.

In order to disable the alarm there should be a red or black button under the streering colum to left side. You must put the ignition in the run position, and then hold this button for thirty seconds it should disable the alrm until you repeat that procedure.

Posted on Dec 30, 2008

  • 1 Answer

SOURCE: How to disable 98 Toyota Avalon Alarm

disable alarm on 96 avalon

Posted on Jan 18, 2010

  • 4793 Answers

SOURCE: how do u disable a 99 Tacoma alarm system, can u

PLEASE DO NOT CUT WIRES...you can buy new remotes and have them coded to the car,takes less than1/2 hour

Posted on Mar 08, 2010

BCAS1298
  • 3092 Answers

SOURCE: 1983 toyota cressida spark plug wire diagram

Hope this helps, also a good site, you found it lol.

e04cb36.gif

Posted on Jul 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse to the alarm for a 2003 gmc yukon


2003 GMC Yukon Car Security Wiring Diagram

www.modifiedlife.com/2003-gmc-yukon-car-security-wiring-diagram/
Whether your an expert GMC Yukon car alarm installer, GMC Yukon ... GMC Yukon, a 2003 GMC Yukon car alarm wiring diagram can save yourself a lot of time. .... Alex, double check ALL your fuses and make sure ALL your fuses are good.

How to Disable a Car Alarm - YouTube

? 2:41
https://www.youtube.com/watch?v=EKbjYlK4g0E
May 13, 2009 - Uploaded by ehowauto
In order to disable a car alarm, an individual will have to locate the horn that was put in and disconnect it, or ...

GMC out alarm fuse Questions & Answers - Fixya

www.fixya.com/tags/out_alarm_fuse/browse/gmc
If you have an alarm installed remove the in line fuse from the alarm and see if that ...Multiple issues with my 2003 GMC Yukon XL and hope someone can offer .

Jan 20, 2016 | GMC Cars & Trucks

1 Answer

WIRING DIAGRAM FOR SONY CDX-GT310


We do not have wiring diagrams. Sorry

Aug 19, 2015 | 1990 Toyota Cressida

1 Answer

Still having a start issue with my 86 toyota cressida


Make sure it has compression as when the cam belt failed it could have bent the valves.
Remove spark plugs and use a compression tester. If you don't ahve access to a compression tester... leave only 1 spark plug in place and try to start it. You should hear a distinct off beat sound of one compression per 2 revolutions. If you don't then it's a compression problem. It's best to confirm low compression with a tester before you go any further.
If this is the case you will need to replace the valves or a fit a good used cylinder head with new gaskets

Apr 28, 2014 | 1986 Toyota Cressida

1 Answer

Wiring diagram for thrttle body map module for 1984 toyota cressida


Autozone.com has free wire diagrams in the repair section. You just need to register which is also free.

Sep 27, 2011 | 1984 Toyota Cressida

1 Answer

1983 toyota cressida spark plug wire diagram


Hope this helps, also a good site, you found it lol.

e04cb36.gif

Jul 14, 2010 | 1983 Toyota Cressida

1 Answer

AC Fan Stuck On High


Thanks for contacting FixYa...
In the future let your father know he should contact us to save himself alot of work and money replacing items that do not need to be replaced. We provide professional advice at no cost.
The symptoms on this point directly to the Blower Motor Resistor located near the Blower Motor. When these Resistors fail, the motor will only operate on High (and Off).
Click on the following: direct, FREE Link, it shows what the part looks like and there is a job diagram to assist him (if needed) to locate the part that needs to be replaced.

http://www.autozone.com/autozone/parts/Duralast-Blower-Motor-Resistor/1991-Toyota-Cressida/_/N-itou5Z91tag?counter=0&filterByKeyWord=resistor&fromString=search&itemIdentifier=420432_0_3330_

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

Jul 02, 2010 | 1991 Toyota Cressida

1 Answer

1jzte from zz30 toyota soarer into mx83 cressida require pin out diagram to suit


ok I'll say what I know..

1.) the only way to get a diagram for the cressida is from the manufacturer or a service center.. I searched high and low for it and couldnt find one so its not available on line (TO MY KNOWLEDGE). The diagram is in the service manual so ordering one of that will get you what you need.

2.) service centers dont like to share

3.) use the cressida harness and a cressida brain and transmission. that way you wont have the problem your having now!!! that what i do on all conversations to avoid such ..all u need is the wiring on the old harness to power the brain.. nothing else needs to be integrated into that circuit.

Mar 06, 2010 | Toyota Cressida Cars & Trucks

1 Answer

Does anyone have the wiring diagram to a\n 86'


Check out faxonautoliterature. They carry genuine dealer service manuals and they list one for your truck. It will have wiring diagrams in it. I have used them before and found their service to be excellent. Hope this helps.

Dec 23, 2009 | 1986 Dodge W150

2 Answers

I have a 1989 toyota cressida. I have no taillights or parking lights. but there is power to the fuse box. I need a diagram so i can trace the wires


get a haynes manual for your car there about $20 new or you can maybe get a cheaper one on amazon they usualy have a wiring diagram for your car

May 21, 2009 | 1989 Toyota Cressida

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

263 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...