- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The best way is to take your time...,Set Emerg brake,start vehicle and put into neutral..Engage 4 wheel drive,look at your dash gauge area for 4 wheel drive light to come on..Put truck in reverse and release park brake..,Back up 10ft.slowly..Then put it in drive and pull up 10 ft.slowly then you should be in four wheel drive..
normaly you drive in 2 wheel dive rear whee lls driving jeep
when you select 4 wheel high or 4 wheel low you engage all 4 wheels bring intthe front axle and all 4 wheels drive high box for slippery roads ice snow etc
important low box only for extreme conditions such as heavy mud deep snow etc
LOW MUST BE SELECTED WHEN STOPPED OTHER WISE DAMAGE TO TRANSMISSION
hope this helps
Check and make sure you have the right bulbs and fuses installed.
However, it sounds like a wiring problem. Probably at the rear of the
vehicle. If you are in a "snow" area state, the ice and snow formation
can break or pull wires apart. Also, check your ground wires.
Turn vehicle on, with foot on brake put vehicle in NEUTRAL. Still holding brakes move 4x4 switch to 4 wheel drive, it should engage. The ECT snow is just s feather that make the transmission take off in 2nd gear so its not a fast take off and you wouldn't skid. Good Luck