Owner's manual is lost (I think my wife packed it somewhere) and the right brake light is out. I removed two bolts to remove the red brake light cover, but it's not budging. I didn't know if there was a hidden screw or bolt still holding it. Didn't want to be too forceful and break it. Any suggestions? Probably very simple but...
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
i would guess the brake warning light is the sensor telling you your pads are low. check the brake fluid and see what level it is, no need to add oil unless it is almost empty but then you would be hearing a squeek grinding noise from brakes. those only cost a few (i think $5) to replace when you do your brakes. but this is just a guess please make sure you have breaks before driving
Study light? Do you mean warning light?
There are sensors clipped into the brake pads on the front left and rear right wheels. When the brake pads get very thin, those sensors rub on the brake rotors, and the light illuminates in the dash indicating that it is time to replace the brake pads.
The light can also illuminate if something damages the wire to the sensor. I usually replace my pads before they get down to the sensors, so I re-use my old sensors. Although the wires are fairly well secured to the suspension, after a few years, the wires can get chaffed from the wind blowing them around, and the damaged wire can turn on the warning light.
When the DSC Dynamic Stability Control light is ON your traction control is OFF. It will sometimes trigger the ABS light and the Rev Limiter it is an engine protection FAIL SAFE mode. Check your brake switch on the brake pedal, this sounds like the problem wen replaced it will reset the Rev limiter, if the ABS light comes Check the wheel sensors
Hi , remove the brake light bulb and look at where the bulb contacts the holder , you may find that you have a hole burned into the holder where the contacts have been arking , if this is the case you will need a replacement kight unit , reagards mark