Question about 2000 Nissan Maxima

1 Answer

Side marker lights do not work

How do I start diagnosing my side marker lights. They don"t work

Posted by on

  • jawin56301 Feb 04, 2009

    I did that yesterday and you were right. The bulbs were bad.

  • Anonymous Mar 21, 2014

    change front side marker lights

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 286 Answers

Hi

No 1 ..Take the lenses off, and check the bulbs, and renew if necessary, check the bulb holder terminals for corrosion, if so spray with WD40 and clean, (with the lights off).

If this does not get them going , you will need a 12 volt test light, and test for live feed to the bulbs lamp holder, with the lights switched on.

Expect you will find corrosion is the problem.

Good Luck

Don´t forget to give a FixYa rating please !

John.



Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why would only one out of 4 marker lights work?


you are right all marker lights come off of one fuse, inside instrument panel, number 29, a 10 amp fuse my manual does not give a lamp number, it has a chart, head lamps (high) lamp 9005 60 w type a, headlamp (low) 9006 51 w type b, front marker lamps 5w type d, for the rear it says to use a lamp 7443 21.5 w type d, I do not use these, I have special lights on mine, hope that it helps

Mar 28, 2015 | 2007 Scion tC

Tip

How To Install Replace Side Marker Lights Mercury Grand Marquis 98-02 1AAuto.com



How To Install Replace Side Marker Lights Mercury Grand Marquis 98-02 1AAuto.com

on May 18, 2012 | 2002 Mercury Grand Marquis

1 Answer

WHY DON'T MY FRONT MAKER AND RUNNING LIGHT WORK


front side marker lights are separate from the day time running lights which are run thru the front turn signal lamps.
it is possible both bulbs have burnt out.

Apr 14, 2013 | 2006 Toyota Tacoma PreRunner

1 Answer

03 chevy venture rt.front parking light&turn light don't work replace bulb&socket


The rapid flashing occurs because of the light problem. If the 20A PARK LP fuse in the underhood fuse block is OK, the front marker lamps and the park lights should turn on when you set the headlamp switch to PARK. If the 10A T/SIG fuse in the instrument panel fuse block is OK, and the ignition switch is on, moving the turn signal multi-function switch to signal a right or left turn should cause the turn signals to flash. If this doesn't happen, check for a missing ground connection to the socket you replaced and check to be sure the replacement lamp was not forced into the socket backwards (it happens).

Sep 17, 2012 | 2003 Chevrolet Venture Passanger

1 Answer

Marker lights do not work. 1994 nissan pickup SE


I would start by checking all the fuses, then check the headlight switch,test it for power as you did the tail light, then check the wiring coming out of the cab down the frame to the rear of bed check for a short but if all fuses are good then will not be a short, may be a bad switch and the most important is the bulbs, make sure they are good.

Jul 05, 2010 | 1994 Nissan Pickup

1 Answer

Had a problem with a right, amber side marker on right side


Usually one of the holes in the marker light where screw goes in, has metal contact where screw meets light, but if not, and they are not push in wire connection type from behind, then just run your white wire up through hole in housing, and bare the end & tighten it up under screw holding light to body. White should be ground, brown should be power.

Jul 02, 2009 | 2004 Dodge Ram 2500

1 Answer

Right side of trailer running lights does not work


Usually one of the holes in the marker light where screw goes in, has metal contact where screw meets light, but if not, and they are not push in wire connection type from behind, then just run your white wire up through hole in housing, and bare the end & tighten it up under screw holding light to body. White should be ground, brown should be power.

Jul 02, 2009 | 2004 Dodge Ram 2500

1 Answer

Front parking/side marker lights


Replace bulb, it has 2 filaments, one is probably burned out.

Sep 10, 2008 | 1996 Jeep Cherokee Sport

2 Answers

Tail Lights, Marker Lights, Air Conditioner lights out


it seems to be a wiring problem .get the wiring checked.

May 22, 2008 | 2005 Pontiac Vibe

Not finding what you are looking for?
2000 Nissan Maxima Logo

Related Topics:

472 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...