Pulled radio to get serial # and now I can't get the radio to go into code input mode. it just says "safe" and the icon for pause is on
If you've entered a bad code a couple times, you need to wait an hour while the radio and ignition are on. Then, turn on the radio, SAFE should be displayed. Then Press the
FM1 button and hold it down, then while holding down the FM1 button,
press and hold the AM buttons so that both buttons are held down simultaneously.
Release the buttons. Now enter the correct code using the radio pre-set
station buttons (one through 4). Button 1 changes the first digit in the code
"1"000, Button "two" changes the second digit in the code 1"0" "three" 00, button changes the third digit, button 4 changes the last digit in the code.
In most cases the first digit is a 1 and won't need to be changed. You
push each pre-set station button multiple times to step through the
digits (1-9) to get the correct code displayed.
Code 1246 would entered by pushing button "2" two times, pushing button
3 four times, and pushing button 4, six times.
After entering the correct security code, push and hold down the FM1
and AM button simultaneously as before until SAFE is displayed, then
release the 2 buttons, and now the radio should now work.
Jan 21, 2013 |
1993 Audi 100